YINGHUA
YINGHUA 5-piece 3.175x15x38mm Up-Down Spiral Carbide Mill Cutters
Five-piece set of 3.175 mm two-flute up-and-down spiral carbide cutters for compression cutting of wood and PVC
- TypeRight-Angle Drills
- Five-piece set covers multiple routing tasks
- Two-flute up-down spiral gives clean edges on both faces
- Tungsten-steel carbide resists wear in abrasive wood composites
- 175 mm shank fits common CNC collets
- Suited for plywood, density board, solid wood and particleboard
Five-piece carbide milling set
This set contains five up-and-down spiral carbide mill cutters sized 3.175 by 15 by 38 millimetres. Each cutter has two flutes designed for compression cutting. The tools are made from tungsten steel and come as single independent packages.
CNC routing compatibility
The cutters fit standard CNC machinery that accepts 3.175 millimetre shank tools. Their up-and-down flute geometry compresses material from both sides, reducing tear-out on wood, plywood, density board, solid wood and particleboard. This design frees the user from separate roughing and finishing passes.
Woodworkers needing compression cuts
Buyers who primarily cut soft plastics, non-ferrous metals or abrasive composites should look at dedicated tooling for those materials. The set is not intended for hand-held drilling or for users under eighteen years of age.
Highlights
- Five-piece set covers multiple routing tasks
- Two-flute up-down spiral gives clean edges on both faces
- Tungsten-steel carbide resists wear in abrasive wood composites
- 175 mm shank fits common CNC collets
- Suited for plywood, density board, solid wood and particleboard
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How deep can the 15 mm flute cut before chip clearance becomes the limiting factor?
The 15 mm flute length sets the maximum depth per pass; deeper cuts require multiple passes to clear chips.
Do the tungsten-steel cutters generate noticeable heat when run continuously in dense board?
Tungsten steel resists heat buildup, but sustained feed rates in dense material will warm the tool — use coolant or air blast for all-day runs.
What shank size must my CNC collet accept for these 3.175 mm bits?
The shank diameter is 3.175 mm, so a 3.175 mm (1/8 inch) ER collet or compatible holder is required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
