YINGHUA
YINGHUA 4X4X12X45 Two Flutes Straight Slot End Mill
Tungsten steel two-flute straight-slot end mill sized 4X4X12X45 cuts wood, acrylic, PVC, nylon, resin and plywood on CNC routers
- TypeRight-Angle Drills
- Two-flute design clears chips efficiently for smooth wood CNC engraving
- Tungsten steel construction resists wear during acrylic and PVC cutting
- 12 mm cutting length handles plywood and resin profiling
- Right-angle drill compatibility simplifies tool changes in CNC setups
- Age-18+ industrial rating ensures safe operation on nylon and wood
CNC engraving cutter for wood and plastics
This carbide end mill has two straight flutes and a tungsten steel body. It is supplied as a single piece for CNC routers that need precise engraving and cutting. The tool works on acrylic, PVC, nylon, resin, wood and plywood. It is intended for industrial cutting only and not for anyone under 18 years.
Upgrade from worn single-flute
A fresh two-flute carbide cutter removes material faster and leaves a cleaner edge than a dull or softer bit. The jump is worth it when finish quality drops or feed rates must be reduced to avoid tear-out on fine detail work.
Fits standard ER collets and CNC spindles
The shank dimensions match common collet sizes so no adapter is required. The straight-flute geometry clears chips upward, reducing recutting in shallow pockets. The cutter frees up spindle time by allowing higher feed rates on the listed materials.
Highlights
- Two-flute design clears chips efficiently for smooth wood CNC engraving
- Tungsten steel construction resists wear during acrylic and PVC cutting
- 12 mm cutting length handles plywood and resin profiling
- Right-angle drill compatibility simplifies tool changes in CNC setups
- Age-18+ industrial rating ensures safe operation on nylon and wood
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter does the 4X4X12X45 end mill require in the collet?
The cutter has a 4 mm shank, so it fits a 4 mm ER collet or shrink-fit holder without adapters.
How deep should the flute length be set in the tool holder for the 12 mm cutting length?
Clamp the shank so the full 12 mm flute length clears the holder face; leaving flute inside the collet causes vibration and breakage.
When should the tungsten steel cutter be replaced during wood and acrylic CNC work?
Replace it when edges show chipping, surface finish degrades, or cutting forces rise sharply — typically after extended use in abrasive materials.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
