YINGHUA
YINGHUA 4X17X45MM UP And DOWN Cut Spiral Carbide Mill Cutter
Carbide spiral cutter with up-and-down flutes for compression cuts in wood and PVC, 4 mm shank, 17 mm cut length, 45 mm overall
- TypeRight-Angle Drills
- Two-flute up-and-down spiral gives clean compression cuts
- Tungsten-steel body resists wear in abrasive materials
- Suited for wood, plywood, density board and particleboard
- 4 mm shank fits 17 mm cutting length at 45 mm overall
- Industrial-grade cutter, not for users under 18 years
YINGHUA 4X17X45MM Compression Cutter
This tungsten steel milling cutter uses up-and-down flutes to compress material during cuts. The 17 mm flute length and 45 mm overall length suit CNC routing tasks. It handles wood, plywood, density board, solid wood and particleboard with a single tool. Sold as one piece in an independent package.
Woodworkers needing clean edges on double-sided
The compression geometry reduces tear-out on both faces of laminates and veneered panels. It is not for handheld drilling or general-purpose twist drilling. Buyers who want more flute length for deeper passes in thick stock should look at something else. The cutter is rated for industrial cutting only and not for users under 18 years.
17 mm cutting depth with 45 mm reach
The 17 mm flute gives comfortable headroom for standard sheet goods and shallow pockets. It runs out when material thickness exceeds that flute length or when chip evacuation becomes difficult in deep slots. The two-flute carbide design balances feed rate and finish quality in the listed wood-based materials.
Highlights
- Two-flute up-and-down spiral gives clean compression cuts
- Tungsten-steel body resists wear in abrasive materials
- Suited for wood, plywood, density board and particleboard
- 4 mm shank fits 17 mm cutting length at 45 mm overall
- Industrial-grade cutter, not for users under 18 years
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
Does this 4 mm shank cutter fit the collet on my CNC router?
The cutter has a 4 mm shank diameter, so it requires a 4 mm ER collet or compatible chuck on the machine spindle.
Will the up-and-down flute geometry chip the melamine face on my 18 mm board?
The compression design shears chips upward and downward simultaneously, reducing tear-out on both faces of 18 mm laminated panels.
How can I confirm the tool is cutting cleanly after the first pass?
Inspect the cut edge for a smooth, burn-free surface and listen for a steady, low-pitched sound rather than chatter or squealing.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
