We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White cylindrical cartridge heater with 200cm cable

YINGHUA

YINGHUA 24V 70W Cartridge Heater 6x20mm 200cm for v6 Volcano Hotend 3d printers accessory

SKU CH-V3MY-XH4TZ

A 24 V 70 W cartridge heater with a 6 × 20 mm rod and 200 cm cable for V6 Volcano hotends

  • 24V 70W output gives fast heat-up for Volcano hotends
  • 6x20mm cartridge fits standard v6 Volcano heater blocks
  • 200cm cable allows flexible routing inside printer frames
  • White ABS housing resists heat during extended prints
  • Single cartridge replaces worn heater for consistent extrusion

24V 70W Cartridge Heater for Volcano Hotend

This 24V 70W cartridge heater measures 6x20 mm and includes a 200 cm lead. It is designed to fit the v6 Volcano heater block used on many 3D printers. The assembly is supplied as a single white heating rod.

Makers upgrading or maintaining a Volcano hotend

The heater suits anyone replacing a worn element or converting a compatible hotend to 24 V 70 W operation. Users whose printer runs on a different voltage, whose hotend requires a different rod diameter or wattage, or who need a shorter or longer cable should look at something else.

24V 70W power rating

The single specification that decides fit is the 24V 70W rating combined with the 6x20 mm rod size. Matching both the voltage and the physical dimensions to the printer’s controller and heater block determines whether this part will work.

Highlights

  • 24V 70W output gives fast heat-up for Volcano hotends
  • 6x20mm cartridge fits standard v6 Volcano heater blocks
  • 200cm cable allows flexible routing inside printer frames
  • White ABS housing resists heat during extended prints
  • Single cartridge replaces worn heater for consistent extrusion

Specifications

No published specifications for this item yet.

Questions about this item

Does my printer need a 24 V power supply to run this 70 W cartridge?

Yes, the heater is rated for 24 V and 70 W, so the printer must supply 24 V to the hot-end circuit.

Will the 6 mm by 20 mm cartridge fit the v6 Volcano heater block I already use?

The rod dimensions are 6 mm diameter by 20 mm length, which matches the standard v6 Volcano heater block bore.

How can I confirm the 70 W cartridge is heating correctly after I install it?

Heat the hot-end to your target temperature and watch the printer display; it should reach and hold the set point without thermal runaway errors.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.