YINGHUA
YINGHUA 2 Flute Spiral Ball Nose End Mill 6x6x22x50
A two-flute tungsten-carbide ball-nose end mill for CNC routing wood, plastics and composites, supplied as a single 6 mm shank cutter with 22 mm flute length and 50 mm overall length
- TypeRight-Angle Drills
- Two-flute spiral design clears chips efficiently for smooth cuts
- Tungsten steel construction resists wear during extended milling sessions
- Ball nose profile produces precise 3-D contours and fine details
- Cuts wood, plastics, acrylic and composite materials without changing tools
- 6 mm shank fits standard CNC collets for quick tool changes
YINGHUA 2 Flute Spiral Ball Nose End Mill
This carbide milling cutter suits CNC router operators cutting wood, plastics, acrylic, PVC, nylon, resin, plywood, hardwood, fibreglass and marble. The 2 flute spiral ball nose geometry delivers precise engraving and cutting performance. It is intended for industrial use only and not for anyone under 18 years of age.
Replaces worn router bits on existing CNC machinery
Swap this tool in when an old cutter leaves rough edges or loses dimensional accuracy on the materials listed above. The tungsten steel construction restores clean cuts without requiring a new machine. The jump is worth it when finish quality drops below the standard your work demands.
Limited to the shank and flute dimensions supplied
The 6 mm shank fits collets sized for that diameter; the 22 mm flute length and 50 mm overall length define the maximum reach and depth of cut. No other interface, holder or coolant standard is implied. Verify your machine accepts these exact dimensions before fitting.
Highlights
- Two-flute spiral design clears chips efficiently for smooth cuts
- Tungsten steel construction resists wear during extended milling sessions
- Ball nose profile produces precise 3-D contours and fine details
- Cuts wood, plastics, acrylic and composite materials without changing tools
- 6 mm shank fits standard CNC collets for quick tool changes
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter does the 6x6x22x50 end mill need for a standard CNC collet?
The 6 mm shank fits directly into any 6 mm ER collet or shrink-fit holder without a reducer sleeve.
How deep should the 22 mm flute length be set in the tool holder to avoid vibration?
Clamp the shank so at least 18 mm of smooth shank sits inside the collet, leaving the full 22 mm flute clear for chip evacuation.
When should the tungsten steel cutter be replaced during heavy plywood routing?
Replace it when the ball-nose radius shows visible flattening or when cut edges develop fuzzy fibres that sanding cannot remove.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
