YINGHUA
YINGHUA 1piece Two Flutes Straight Slot End Mill 3.175X3.175X28X50
Two-flute tungsten-steel end mill for CNC engraving and cutting wood, acrylic, PVC, nylon and resin, 3.175 mm shank, 28 mm flute length, 50 mm overall
- TypeRight-Angle Drills
- Two-flute design enables smooth chip evacuation in wood and plastic
- Tungsten steel construction provides hardness for engraving acrylic, PVC and nylon
- 175 mm shank fits standard CNC collets for secure holding
- 28 mm cutting length allows deeper passes in plywood and resin
- 50 mm overall length gives rigidity for precise profiling cuts
Two-flute carbide end mill
This two-flute straight-slot end mill is made from tungsten steel for CNC engraving and cutting. It suits operators who need a single replacement cutter for wood, acrylic, PVC, nylon, resin or plywood work. The tool is intended for industrial cutting use only and is not for anyone under 18 years of age.
Dimensions and cutting parameters
The shank and cutting diameter are both 3.175 mm, the flute length is 28 mm and the overall length is 50 mm. These figures define the tool’s reach and engagement in the spindle. No cooling or power-draw data is supplied for the cutter itself.
Sustained cutting behaviour
Under continuous CNC operation the carbide construction maintains its edge through extended passes in the listed materials. The straight-slot geometry evacuates chips during prolonged profiling or pocketing cycles. The tool is not designed for hazardous materials or non-industrial applications.
Highlights
- Two-flute design enables smooth chip evacuation in wood and plastic
- Tungsten steel construction provides hardness for engraving acrylic, PVC and nylon
- 175 mm shank fits standard CNC collets for secure holding
- 28 mm cutting length allows deeper passes in plywood and resin
- 50 mm overall length gives rigidity for precise profiling cuts
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How do I install the 3.175 mm shank end mill in my CNC collet, and what step do people often miss?
Insert the 3.175 mm shank fully into the ER collet, tighten the nut to the specified torque, then verify zero run-out before cutting; skipping the run-out check causes vibration and premature wear.
What maintenance or replacement will this tungsten steel cutter need during its life?
The two-flute carbide edges dull over time; plan to resharpen or replace the cutter when cut quality drops on acrylic, PVC, nylon, resin, wood or plywood.
What limit appears first during sustained engraving with the 28 mm flute length?
Heat builds up in the 28 mm cutting zone during long passes, so reduce feed rate or use air blast to avoid overheating the tungsten steel flutes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
