YINGHUA
YINGHUA 150M HDMI KVM Extender Matrix over IP Cat6 RJ45 One-to-Many AU Plug
Extends HDMI video and USB keyboard-mouse control up to 150 m over a single Cat6 cable, supports 1920×1080 at 60 Hz and IR remote.
- TypeHDMI
- Extend HDMI up to 150 m over a single Cat6 cable
- Control sources remotely with keyboard and mouse via USB KVM
- Distribute to multiple displays using standard network switches
- Support up to 99 device groups for flexible matrix routing
- Deliver 1920 x 1080 resolution at 60 Hz
One-to-many HDMI KVM extender
The YINGHUA 150M HDMI KVM Extender Matrix sends 1080p video and USB control signals up to 150 metres over a single Cat6 cable. It uses standard Ethernet TCP/IP protocol to route one source to many displays through a network switch with PoE support. The system scales to 99 device groups for distributed AV deployments.
1920 x 1080 resolution at 60 Hz
This extender transmits HDMI video and audio at a maximum of 1920 by 1080 pixels at 60 Hz. That ceiling decides whether the unit fits a 1080p workflow or falls short for higher-resolution sources. No other video formats or refresh rates are supported by the hardware.
Plug-and-play over Cat6 with IR kit
Connect transmitter and receiver with one Cat6 cable up to 150 m, then link keyboard, mouse and the supplied IR cable for remote control. The single-receiver package limits each endpoint to one display; additional receivers must be sourced separately for multi-monitor nodes. PoE switches simplify power but are not included.
Highlights
- Extend HDMI up to 150 m over a single Cat6 cable
- Control sources remotely with keyboard and mouse via USB KVM
- Distribute to multiple displays using standard network switches
- Support up to 99 device groups for flexible matrix routing
- Deliver 1920 x 1080 resolution at 60 Hz
Specifications
| Type | HDMI |
|---|
Questions about this item
What resolution will I actually see on the display at the far end of the 150 m run?
The extender delivers up to 1920 x 1080 at 60 Hz over the full 150 metre Cat6 link.
What does the IP matrix cap at for simultaneous device groups?
It supports up to 99 groups of transmitters and receivers on the same network switch.
What cabling and power does the receiver need to fit into my rack?
One Cat6 cable carries video, USB and power to the RX unit, which uses the supplied AU plug adapter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



