YINGHUA
YINGHUA 10x10x25x75MM HRC45 Altin Coated 4 Flutes Solid Carbide Roughing End Mill
Solid carbide roughing end mill with AlTiN coating cuts aluminium, cast iron, steel and stainless steel up to HRC45 hardness
- TypeRight-Angle Drills
- HRC45 hardness handles tough steels and stainless
- Altin coating extends tool life in abrasive cuts
- Four-flute design removes chips efficiently in roughing
- 10 mm shank fits standard collets and holders
- 75 mm overall length reaches deep cavities
10 mm Solid Carbide Roughing End Mill
This 10 mm diameter solid carbide end mill features four flutes and an Altin coating for roughing operations. The 25 mm cutting length and 75 mm overall length suit CNC milling of aluminum, cast iron, steel, stainless steel and copper. It is sold new and individually packaged.
Suited for high-removal roughing passes
Machinists who need aggressive stock removal in the listed metals will benefit from the HRC45-rated substrate and coating combination. The tool is not intended for finishing passes that require a finer surface finish or for materials harder than HRC45. Buyers needing a different flute count, coating or cutting diameter should consider other options.
HRC45 work-material hardness rating
The cutter is rated for workpiece hardness up to HRC45, which determines whether it can handle your specific alloy. Exceeding this hardness will accelerate wear and risk tool failure. Verify your material hardness before selecting this end mill.
Highlights
- HRC45 hardness handles tough steels and stainless
- Altin coating extends tool life in abrasive cuts
- Four-flute design removes chips efficiently in roughing
- 10 mm shank fits standard collets and holders
- 75 mm overall length reaches deep cavities
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter and overall length does the 10 mm cutter need in the holder?
The tool has a 10 mm shank and 75 mm overall length, so the collet or chuck must accept 10 mm and provide at least 75 mm clearance.
How do you install the end mill without damaging the Altin coating?
Clean the shank and collet, insert the 10 mm shank fully, tighten the collet evenly, and avoid side loads during the first plunge to protect the coating.
When should the roughing cutter be replaced based on the HRC45 rating?
Replace the cutter when the roughing edges on the four flutes show visible chipping or when cutting forces increase noticeably in steel up to HRC45.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
