YINGHUA
YINGHUA 10Psc 6.35x32mm UP And DOWN Cut Two Flutes Spiral Carbide Mill Tool Cutters
Set of ten tungsten-steel up-and-down-cut carbide end mills with 6.35 mm shank and 32 mm cutting length for CNC wood routing
- TypeRight-Angle Drills
- 10-piece set covers multiple CNC routing jobs
- Up-and-down compression cut prevents tear-out on both faces
- Two-flute spiral geometry clears chips efficiently
- Tungsten steel construction resists wear in abrasive woods
- 35 mm shank fits standard CNC router collets
10-piece tungsten carbide compression cutters
This set contains ten spiral end mills with a 6.35 mm shank and 32 mm cutting length. Each tool uses an up-and-down flute geometry designed to compress wood fibres during CNC routing. The tungsten steel construction resists wear when cutting plywood, solid wood, particleboard and similar sheet materials.
For CNC operators cutting double-sided boards
Woodworkers who need clean top and bottom edges on laminated panels will benefit from the compression design. Buyers who only cut single-face material or require specialised profiles such as V-groove or ball-nose should consider different cutter types.
Standard 6.35 mm shank fits common collets
Installation is a simple collet change on most CNC routers; ensure the tool is seated to the correct depth and the collet is clean. Common issues include vibration from excessive stick-out and premature wear if feed rates are too low for the two-flute geometry.
Highlights
- 10-piece set covers multiple CNC routing jobs
- Up-and-down compression cut prevents tear-out on both faces
- Two-flute spiral geometry clears chips efficiently
- Tungsten steel construction resists wear in abrasive woods
- 35 mm shank fits standard CNC router collets
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What collet size is required for the 6.35 mm shank on these cutters?
A 6.35 mm (1/4 inch) collet is needed to hold the shank securely in your CNC router spindle.
Will the up-and-down flute geometry reduce tear-out on the plywood and density board I already cut?
Yes, the compression design pushes chips both upward and downward, giving clean top and bottom edges on plywood, density board and solid wood.
How can I confirm the cutters are performing correctly after the first test cut?
Check that both faces of the workpiece show no splintering and measure the cut width to match the 6.35 mm tool diameter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
