YINGHUA
YINGHUA 10pcs Two Flute Straight Slot CNC Router Bits 6x6x52x80
Set of 10 solid carbide router bits for engraving and cutting wood, acrylic, PVC, nylon, resin and plywood
- TypeRight-Angle Drills
- 10-piece set provides multiple cutters for continuous CNC work
- Tungsten steel construction resists wear during extended routing sessions
- Two-flute straight-slot geometry clears chips cleanly in wood and plastics
- 52 mm cutting length and 80 mm overall reach suit deep-profile jobs
- Right-angle drill compatibility simplifies tool changes on standard CNC spindles
CNC router bit set for wood and plastics
This 10-piece set supplies solid carbide two-flute straight bits for CNC routing work. The cutters handle engraving and cutting in acrylic, PVC, nylon, resin, wood and plywood. They are intended for industrial cutting use only and are not for anyone under 18 years of age.
Thermally stable carbide for sustained cutting
Tungsten steel construction resists heat build-up during extended routing passes, keeping the cutting edges consistent. The two-flute geometry evacuates chips efficiently, which helps control noise and reduces power draw on the spindle. No coolant or special ventilation is required for the listed materials.
Boxed set ready for workshop storage
Ten bits come in a single box, simplifying inventory and tool changes on the machine. The straight-slot profile suits standard collets without proprietary adapters. Buyers who need ball-nose, V-groove or compression profiles will need separate tooling.
Highlights
- 10-piece set provides multiple cutters for continuous CNC work
- Tungsten steel construction resists wear during extended routing sessions
- Two-flute straight-slot geometry clears chips cleanly in wood and plastics
- 52 mm cutting length and 80 mm overall reach suit deep-profile jobs
- Right-angle drill compatibility simplifies tool changes on standard CNC spindles
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How do I install the 6 mm shank bits into my CNC collet without damaging them?
Insert each 6 mm shank fully into the collet, tighten evenly, and avoid side pressure on the 52 mm cutting length — the step most users skip is verifying zero run-out before the first plunge.
When will the solid carbide flutes on these 80 mm overall-length bits need replacement?
Replace the bits when the two flutes show visible rounding or when cut quality drops on acrylic, PVC, nylon, resin, wood or plywood — solid carbide wears slowly but cannot be resharpened economically.
What is the first limit I will hit during a long engraving session with these tungsten-steel cutters?
Heat buildup in the 52 mm flute section is the first limit; sustained cuts without chip clearance or coolant will dull the edges faster than the 10-piece supply can cover.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
