YINGHUA
YINGHUA 10pcs Two Flute CNC Router Bits 6x6x25x50mm
Set of ten solid-carbide router bits with two flutes for engraving and cutting wood, acrylic, PVC, nylon and resin
- TypeRight-Angle Drills
- Ten-piece set covers multiple routing jobs
- Tungsten steel construction resists wear during cutting
- Two-flute design clears chips for smoother finish
- Suitable for acrylic, PVC, nylon, resin, wood and plywood
- 6 mm shank with 25 mm cutting length fits common CNC collets
10-piece tungsten-steel router bit set
This set contains 10 solid-carbide two-flute straight bits sized 6x6x25x50mm. They are designed for CNC routing and engraving on wood, plywood, acrylic, PVC, nylon and resin. The tungsten-steel construction provides the hardness required for clean cuts in these materials. It suits hobbyists and small workshops running desktop CNC machines.
Straight-shank fit for standard collets
Each bit uses a straight shank that fits common 6mm collets on desktop CNC routers. Installation is a simple collet change with no adapters needed. The main risk is over-tightening the collet or running excessive feed rates, which can snap the carbide. The bits are not for handheld drills and must not be used by anyone under 18 years old.
Ten bits give spares for production runs
The 10-piece box lets you rotate cutters during long jobs without stopping to resharpen. They handle fine engraving and profiling in the listed plastics and woods comfortably. Carbide will chip if used on metals, stone or abrasive composites, and the 25mm cutting length limits depth per pass in thick stock.
Highlights
- Ten-piece set covers multiple routing jobs
- Tungsten steel construction resists wear during cutting
- Two-flute design clears chips for smoother finish
- Suitable for acrylic, PVC, nylon, resin, wood and plywood
- 6 mm shank with 25 mm cutting length fits common CNC collets
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How can I confirm the bits are cutting cleanly after installing them in my CNC router?
Run a test cut in wood or acrylic; the tungsten-steel flutes should leave smooth edges without chipping or burning.
What comes in the package and is anything else needed to start cutting?
The box contains 10 solid-carbide two-flute bits measuring 6x6x25x50 mm; no extra accessories are included, so ensure your collet matches the 6 mm shank.
Which version of this bit set should I choose for engraving plywood and PVC?
This single 10-piece set with 25 mm cutting length and 50 mm overall length is designed for fine engraving and cutting in plywood, PVC, acrylic, nylon, resin and wood.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
