YINGHUA
YINGHUA 10pcs Two Flute CNC Router Bits 3.175X3.175X28x50
Set of ten solid-carbide two-flute router bits for engraving and cutting wood, acrylic, PVC, nylon and resin
- TypeRight-Angle Drills
- 10-piece set keeps spares ready for CNC routing
- Two-flute design clears chips efficiently in wood and plastics
- Tungsten-steel carbide holds a sharp edge through repeated cuts
- 175 mm shank fits standard collets without adapters
- Suited for acrylic, PVC, nylon, resin, wood and plywood
10-piece carbide router bit set
This 10-piece set supplies tungsten steel straight-slot cutters for CNC engraving and cutting. The bits handle acrylic, PVC, nylon, resin, wood and plywood. They are intended for industrial use only and must not be used by anyone under 18 years of age.
3.175 mm shank and 28 mm cutting length
Each bit has a 3.175 mm shank diameter and a 28 mm flute length with an overall length of 50 mm. Match these dimensions to your collet and tool holder before ordering, as no other shank sizes are included.
Direct collet fit, check run-out on install
The bits slide straight into a 3.175 mm collet with no adapter required. Verify concentricity after tightening to avoid vibration, and keep the cutting edges clear of debris to prevent premature wear.
Highlights
- 10-piece set keeps spares ready for CNC routing
- Two-flute design clears chips efficiently in wood and plastics
- Tungsten-steel carbide holds a sharp edge through repeated cuts
- 175 mm shank fits standard collets without adapters
- Suited for acrylic, PVC, nylon, resin, wood and plywood
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What does the 3.175 mm shank diameter mean for my CNC router?
The 3.175 mm shank fits collets and tool holders made for that exact size, which is common on many desktop CNC machines and some trim routers.
What does the solid carbide construction mean for tool life when cutting the listed materials?
Tungsten steel carbide keeps a sharp edge longer than high-speed steel when engraving acrylic, PVC, nylon, resin, wood and plywood, reducing how often you need to change bits.
What do the 28 mm and 50 mm dimensions tell me about reach and clearance?
The 28 mm cutting length sets the maximum depth of cut in a single pass, while the 50 mm overall length determines how far the bit extends from the collet for workpiece clearance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
