YINGHUA
YINGHUA 10Pcs 8x35mm UP And DOWN Cut Two Flutes Spiral Carbide Mill Tool Cutters
Set of ten tungsten-steel spiral cutters with up-and-down flutes for clean CNC routing of wood and board materials
- TypeRight-Angle Drills
- 10-piece set covers multiple CNC jobs
- Up-and-down cut flutes give clean top and bottom edges
- Tungsten steel carbide resists wear in abrasive woods
- Two-flute spiral clears chips for smooth feed
- Suited for wood, plywood, density board and particleboard
CNC Compression Cutter Set
This 10-piece set supplies tungsten-steel spiral mill cutters sized 8x35 mm for CNC router work. The up-and-down flute geometry produces clean edges on both faces of the workpiece. Two flutes per tool balance chip evacuation with surface finish. Every cutter is new and ready for industrial routing tasks.
Woodworkers and sign makers
The compression profile excels on plywood, density board, solid wood and particleboard where tear-out on the top or bottom surface must be avoided. Shops cutting abrasive composites or metals should select dedicated tooling instead. The cutters are rated for users aged 18 and over and are intended for industrial cutting only.
Up-and-down flute compression
The opposing spiral direction shears fibres downward on the upper flutes and upward on the lower flutes, compressing the material toward the centre of the cut. This single geometry decides whether the part leaves a clean, splinter-free edge on double-sided panels.
Highlights
- 10-piece set covers multiple CNC jobs
- Up-and-down cut flutes give clean top and bottom edges
- Tungsten steel carbide resists wear in abrasive woods
- Two-flute spiral clears chips for smooth feed
- Suited for wood, plywood, density board and particleboard
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
Does the tungsten-steel construction keep the 8x35 mm up-and-down cutters cool during long CNC sessions?
Tungsten steel dissipates heat well, so the 10-piece set stays cooler than high-speed steel when cutting wood, plywood, density board, solid wood or particleboard all day.
What shank size must my CNC router collet accept for these 8x35 mm compression cutters?
The cutters have an 8 mm shank, so your router needs an 8 mm collet or an 8 mm ER collet to hold them securely.
Will these two-flute spiral cutters chip the edges on the older MDF sheets I still have in stock?
The up-and-down compression geometry shears fibres both upward and downward, giving clean edges on MDF and other density boards without tear-out.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
