YINGHUA
YINGHUA 10Pcs 6x42mm UP DOWN Cut Spiral Carbide Mill Cutter
A set of ten tungsten-steel compression cutters with up-and-down flutes for clean CNC routing of wood and board materials
- TypeRight-Angle Drills
- 10-piece tungsten-steel set covers multiple CNC jobs
- Up-and-down two-flute spiral gives clean compression cuts in wood
- Right-angle shank fits standard CNC router collets
- Tungsten steel construction resists wear during plywood and particleboard routing
- Industrial-grade cutters restricted to users aged 18 and over
10-piece tungsten steel router bit set
This set contains ten 6 x 42 mm up-and-down cut spiral carbide mill cutters designed for CNC router compression work on wood. The two-flute geometry and tungsten steel construction deliver clean edges on plywood, density board, solid wood and particleboard. They are intended for industrial cutting applications only.
Replaces worn or single-direction compression bits
Swapping to up-and-down cut geometry is worthwhile when top and bottom tear-out on double-sided panels becomes unacceptable. The opposing flutes shear fibres in both directions, so the improvement is clear on through-cuts in laminated sheet goods. Not suited for buyers who need larger shank diameters or specialised profiles for non-wood materials.
Standard 6 mm shank fits common ER collets
Installation is a straightforward collet change; no machine modification is required. The main risk is exceeding recommended feed rates, which can snap the brittle carbide flutes. Users under 18 years must not handle the bladed tools, and the cutters must be reserved for approved wood-based materials only.
Highlights
- 10-piece tungsten-steel set covers multiple CNC jobs
- Up-and-down two-flute spiral gives clean compression cuts in wood
- Right-angle shank fits standard CNC router collets
- Tungsten steel construction resists wear during plywood and particleboard routing
- Industrial-grade cutters restricted to users aged 18 and over
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter do these 6x42mm spiral carbide cutters need in a CNC router collet?
The cutters have a 6 mm shank, so they require a 6 mm ER collet or equivalent holder that matches the router spindle taper.
How should the two-flute up-down compression geometry be oriented when installing the cutter in the collet?
Insert the cutter so the flutes face the cutting direction; the up-cut section pulls chips upward while the down-cut section presses the top surface down for clean edges on both faces.
When should the tungsten-steel cutters be replaced during wood, plywood or particleboard work?
Replace them when the edges show visible rounding, burning appears on the workpiece, or cutting force increases noticeably during routing operations.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
