YINGHUA
YINGHUA 10Pcs 6x25mm UP And DOWN Cut Two Flutes Spiral Carbide Mill Tool Cutters
A 10-piece set of 6x25 mm tungsten-steel spiral compression cutters with up-and-down flutes for clean CNC routing of wood, plywood and particleboard
- TypeRight-Angle Drills
- 10-piece set equips CNC routers for continuous production
- Up-and-down compression flutes prevent tear-out on both faces
- Two-flute spiral geometry clears chips for smooth cuts
- Tungsten steel construction resists wear in abrasive wood materials
- Suited for plywood, density board, solid wood and particleboard
10-Piece Tungsten Steel Compression Cutters
This 10-piece set provides 6x25mm up-and-down cut two-flute spiral carbide mill tool cutters built from tungsten steel. They are designed for CNC router compression wood end milling. The cutters suit operators who need clean edges on both faces of the workpiece.
Replaces Worn Single-Direction Router Bits
These compression cutters replace standard up-cut or down-only bits that leave tear-out on the top or bottom surface. The switch is worthwhile when cutting wood, plywood, density board, solid wood or particleboard where double-sided finish quality matters for the final part.
Direct Shank Fit for Compatible CNC Collets
Installation consists of seating the 6 mm shank into a matching collet and tightening to the machine’s specified torque. Common issues include running excessive feed rates that chip the carbide, insufficient dust extraction causing heat buildup, or using a collet size that does not match the shank diameter.
Highlights
- 10-piece set equips CNC routers for continuous production
- Up-and-down compression flutes prevent tear-out on both faces
- Two-flute spiral geometry clears chips for smooth cuts
- Tungsten steel construction resists wear in abrasive wood materials
- Suited for plywood, density board, solid wood and particleboard
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter must the CNC router collet accept for these 6x25mm carbide mill cutters?
The cutters have a 6 mm shank, so the collet or chuck must grip a 6 mm round shank.
How do you install the up-and-down cut spiral cutters in a CNC router without damaging the flutes?
Insert the 6 mm shank fully into the collet, tighten the collet nut to the router maker's torque, and avoid side loading while the spindle spins up.
When should the 10-piece tungsten-steel cutter set be replaced during heavy plywood or particleboard work?
Replace cutters when the up-and-down flutes show visible dulling, chipping, or when cut quality drops on dense board.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
