YINGHUA
YINGHUA 10Pcs 6x22mm UP DOWN Cut 2 Flutes Blue Nano Coating Carbide Mill Tool Cutters
A 10-piece set of 6x22 mm up/down-cut carbide end mills with blue nano coating for clean CNC routing of wood, plywood and particleboard
- TypeRight-Angle Drills
- 10-piece set gives you plenty of cutters for CNC routing jobs
- Up-and-down compression flutes cut wood cleanly on both faces
- Blue nano coating on tungsten steel resists wear during heavy use
- Two-flute geometry clears chips fast for smooth edges in plywood
- Suitable for density board, solid wood, particleboard and similar materials
CNC Router Compression End Mills
This 10-piece set provides tungsten steel cutters designed for CNC router work. The blue nano coating helps reduce friction during cutting operations. They are intended for wood, plywood, density board, solid wood and particleboard. The product is new and sold as a 10-pack.
Up Down Cut Geometry for Clean Edges
The up and down cut compression design pulls chips toward the centre to prevent tear-out on both faces of the workpiece. This geometry replaces single-direction bits that leave rough surfaces on the top or bottom layer. The jump is worth it when you need clean edges on double-sided laminates or veneered panels without secondary sanding.
Check Shank Fit and Machine Rigidity
Verify that your CNC router accepts a 6 mm shank before ordering. Ensure the collet and spindle runout are within tolerance to avoid premature wear. The cutters are rated for industrial cutting only and must not be used by anyone under 18 years of age.
Highlights
- 10-piece set gives you plenty of cutters for CNC routing jobs
- Up-and-down compression flutes cut wood cleanly on both faces
- Blue nano coating on tungsten steel resists wear during heavy use
- Two-flute geometry clears chips fast for smooth edges in plywood
- Suitable for density board, solid wood, particleboard and similar materials
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter do the 6x22 mm cutters need in the collet?
The cutters have a 6 mm shank, so use a 6 mm ER collet or equivalent holder that matches your CNC router spindle.
How do I install the up-and-down compression cutters without chipping the flutes?
Insert each cutter fully into the collet, tighten the nut to the router maker’s torque spec, and avoid side-loading when you jog the machine to the first cut.
When should I replace the blue nano-coated carbide cutters?
Replace them when the up-cut and down-cut edges show visible rounding, burning on wood or plywood, or when feed rates must drop to maintain cut quality.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
