YINGHUA
YINGHUA 10Pcs 6x22mm Blue UP And DOWN Cut Two Flutes Spiral Carbide Mill Tool Cutters
Set of ten tungsten-steel up-and-down spiral cutters, 6 × 22 mm, for clean CNC routing of wood and board materials
- TypeRight-Angle Drills
- 10-piece set provides multiple cutters for CNC routing
- Up-and-down cut geometry compresses wood fibres for clean edges
- Two-flute spiral design clears chips efficiently during milling
- Tungsten steel construction resists wear on abrasive materials
- Cuts wood, plywood, density board and particleboard
10-piece carbide end-mill set for CNC wood routing
This pack contains ten 6 mm shank by 22 mm cut-length spiral cutters made from tungsten steel. The two-flute up-and-down compression geometry is designed for clean edges on both faces of sheet material. It targets CNC router operators who need a ready supply of identical tooling for production runs.
6 mm shank diameter fits common collets
Every cutter in the set shares a 6 mm shank, so compatibility depends on whether your machine uses that collet size. The 22 mm flute length determines the maximum depth of cut in a single pass. Verify both dimensions against your spindle and workpiece thickness before purchasing.
Simple collet change; watch chip load
Installation is a standard collet swap: loosen the nut, insert the 6 mm shank fully, and retighten to the maker’s torque value. Common issues arise when feed rates are too low, causing rubbing instead of cutting, or when dust extraction is inadequate, leading to recut chips and premature edge wear.
Highlights
- 10-piece set provides multiple cutters for CNC routing
- Up-and-down cut geometry compresses wood fibres for clean edges
- Two-flute spiral design clears chips efficiently during milling
- Tungsten steel construction resists wear on abrasive materials
- Cuts wood, plywood, density board and particleboard
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How does the 22 mm flute length affect cutting depth in a CNC router?
The 22 mm flute length sets the maximum cutting depth per pass, so deeper slots require multiple passes or a longer tool.
What does the up-and-down two-flute geometry do for chip evacuation?
The opposing helix pulls chips both upward and downward, compressing the workpiece and reducing tear-out on top and bottom surfaces.
What shank size must the collet accept for these 6 mm cutters?
The cutters have a 6 mm shank, so the collet or holder must be sized for 6 mm to grip them securely.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
