YINGHUA
YINGHUA 10Pcs 4x25mm Up Down Cut Carbide Mill Cutter
Set of ten tungsten-steel up-down cut carbide mills for CNC routing wood and board materials
- TypeRight-Angle Drills
- 10-piece set keeps CNC projects running without reordering
- Up-down cut geometry reduces tear-out on wood and plywood
- Two-flute spiral design clears chips for smoother finish
- Tungsten steel construction resists wear during heavy routing
- 4 mm shank by 25 mm length fits standard collets
10-piece carbide mill set for CNC routing
This 10-piece set supplies 4 mm by 25 mm up-down cut carbide mill cutters designed for CNC router compression work. The two-flute spiral geometry suits wood, plywood, density board, solid wood and particleboard. Tungsten steel construction provides the hardness required for clean edges in sheet goods. The pack is intended for workshop and light industrial routing tasks.
Thermals noise and power draw in normal use
Carbide tooling runs cooler than high-speed steel because the material retains hardness at higher cutting temperatures. The up-down shear action compresses chips toward the centre of the cut, reducing heat buildup on the workpiece surface. No electrical power is drawn by the cutters themselves; load depends entirely on the router spindle and feed rates chosen by the operator.
Replaces worn compression bits for cleaner edges
The set replaces dull or chipped compression end mills that leave tear-out on double-sided laminates or veneered panels. Upgrading is worthwhile when finish quality drops on through-cuts in plywood or density board and re-sharpening is no longer cost-effective. Not suited for buyers who need larger diameters, different flute counts or tooling for non-ferrous metals and plastics.
Highlights
- 10-piece set keeps CNC projects running without reordering
- Up-down cut geometry reduces tear-out on wood and plywood
- Two-flute spiral design clears chips for smoother finish
- Tungsten steel construction resists wear during heavy routing
- 4 mm shank by 25 mm length fits standard collets
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How do I install the 4x25mm up-down cut carbide mill cutter in my CNC router, and what step is often missed?
Secure the 4mm shank in a matching ER collet, tighten the collet nut to the router's specified torque, then verify the cutter runs true before cutting; many users skip the run-out check and get vibration.
What maintenance or replacement will the 10-piece tungsten steel cutter set need later?
The tungsten steel flutes will dull after extended use in wood, plywood, density board, solid wood and particleboard; replace any cutter that shows chipped edges or requires excessive feed force.
What limit appears first when running these compression end mills continuously in dense material?
Heat buildup in the two-flute carbide body becomes the limiting factor; reduce spindle speed or increase feed rate to clear chips and prevent premature edge degradation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
