YINGHUA
YINGHUA 10Pcs 10x42mm UP DOWN Cut Two Flutes Carbide Mill Cutter
Ten-piece carbide milling-cutter set with 10 × 42 mm up-down spiral flutes for clean CNC routing of wood and composite boards
- TypeRight-Angle Drills
- 10-piece set covers multiple CNC jobs
- Up-down flute design gives clean edges on both faces
- Two-flute carbide cuts wood and composite boards
- Tungsten steel construction resists wear during long runs
- Industrial-grade cutters suited for users over 18
CNC Router Compression Cutters
This set contains ten tungsten-steel end mills sized 10x42 mm with up-cut and down-cut flutes. They are designed for CNC routers that require clean edges on both faces of the workpiece. The right-angle drill geometry suits standard collets. Industrial users cutting wood-based panels will find the compression profile reduces tear-out on laminated surfaces.
Capacity and Material Limits
The cutters handle wood, plywood, density board, solid wood and particleboard in a single pass. Tungsten steel retains sharpness longer than high-speed steel on abrasive composites. The 42 mm flute length sets the maximum depth of cut per engagement. Hard plastics, non-ferrous metals or materials outside the listed wood types are not covered by the specification.
Ten-Piece Pack Convenience
Ten identical cutters ship together so a worn tool can be swapped without interrupting a production run. No software, collets or mounting hardware are included in the package. The quantity supports batch routing jobs where consistent diameter is critical. Users under 18 years old are prohibited from operating the bladed tools.
Highlights
- 10-piece set covers multiple CNC jobs
- Up-down flute design gives clean edges on both faces
- Two-flute carbide cuts wood and composite boards
- Tungsten steel construction resists wear during long runs
- Industrial-grade cutters suited for users over 18
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
Will the 10 mm shank of these cutters fit the collet on my older CNC router?
The cutters have a 10 mm shank, so they will fit any collet or tool holder sized for 10 mm.
How can I confirm the up-cut and down-cut flutes are cutting cleanly after installation?
Run a test cut in scrap wood; a clean edge on both the top and bottom faces shows the compression geometry is working.
The listing says 10 pcs — does that mean ten complete cutters or ten individual flutes?
The package contains ten complete 10x42 mm carbide cutters, each with two flutes; no extra parts are included.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
