YINGHUA
YINGHUA 10pc 6x32x60mm BlueNano Two Flutes Up Down Cut Spiral Carbide End Mill Bits
Set of ten 6×32×60 mm two-flute up/down spiral carbide end mills for clean compression cuts in wood, plywood and PVC
- TypeRight-Angle Drills
- 10-piece set covers multiple jobs
- Tungsten steel construction resists wear
- Up-down spiral compression reduces tear-out
- Cuts wood, plywood, density board, particleboard
- 6 mm shank, 32 mm flute, 60 mm overall
10-piece BlueNano Carbide End Mill Set
This set contains 10 carbide end mill bits sized 6x32x60mm with a BlueNano coating. They feature a two-flute up-cut and down-cut spiral design for compression cutting. The tools are made from tungsten steel for durability. They are intended for use with CNC machinery.
Fits CNC routers and compatible tool holders
The 6mm shank fits standard collets and tool holders used in CNC routing. The up-down spiral geometry compresses material fibres during cutting, which reduces tear-out on both faces of the workpiece. This design frees the user from sanding or finishing rough edges on double-sided panels.
Replaces single-direction spiral bits for wood
These cutters replace standard up-cut or down-cut bits when clean edges on both sides are required. They are suited for wood, plywood, density board, solid wood and particleboard. The upgrade is worth it when tear-out on the bottom surface ruins the part or adds excessive post-processing time. Not for buyers who need single-flute bits for chip clearance in deep slots or tools rated for non-ferrous metals.
Highlights
- 10-piece set covers multiple jobs
- Tungsten steel construction resists wear
- Up-down spiral compression reduces tear-out
- Cuts wood, plywood, density board, particleboard
- 6 mm shank, 32 mm flute, 60 mm overall
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How quickly will the 6 mm tungsten-steel cutting edges wear when routing abrasive particleboard all day?
The BlueNano coating on the tungsten-steel flutes reduces abrasion, so the 32 mm cutting length stays sharp longer in particleboard and plywood.
Do the up-cut and down-cut spirals generate noticeable heat or vibration during continuous CNC runs?
The opposing spirals compress chips toward the centre, lowering heat buildup and vibration during extended cutting sessions.
What shank size must my CNC collet or router accept to hold these 6 mm bits?
Each bit has a 6 mm shank, so the machine needs a 6 mm collet or compatible holder.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
