YINGHUA
YINGHUA 10pc 3.175x17x38mm Two-Flute Up/Down Carbide Mill Cutters
Ten 3.175 mm carbide end mills with up/down flutes for clean compression cuts in wood and PVC
- TypeRight-Angle Drills
- Ten-piece carbide set covers multiple routing jobs
- 175 mm shank fits standard CNC collets
- 17 mm flute length handles deep profiles
- Up/down spiral gives clean edges on wood and PVC
- Tungsten steel body resists wear during long runs
CNC Router Bits for Wood and PVC
This set contains ten carbide end mills sized 3.175 by 17 by 38 millimetres. Each cutter uses a two-flute up-and-down spiral geometry for compression cutting. The tungsten steel construction suits CNC routers and similar machines. Buyers receive ten individually packaged bits ready for workshop use.
Replaces Worn Single-Direction Bits
Compression geometry reduces tear-out on both faces of plywood, density board and solid wood. The up-and-down flutes push chips away from the cut while holding the workpiece flat. Switching from standard up-cut or down-cut bits is worthwhile when edge quality on both sides matters. The ten-piece pack also covers bulk replacement for production runs.
Suits CNC Operators Cutting Sheet Goods
Woodworkers and sign makers who need clean edges on particleboard, solid wood or PVC will benefit. The 3.175 millimetre shank fits common collets, but users must verify machine compatibility. Buyers needing larger diameters, different shank sizes or specialised coatings should look at other tooling options.
Highlights
- Ten-piece carbide set covers multiple routing jobs
- 175 mm shank fits standard CNC collets
- 17 mm flute length handles deep profiles
- Up/down spiral gives clean edges on wood and PVC
- Tungsten steel body resists wear during long runs
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter fits the 3.175 mm cutters?
These cutters have a 3.175 mm shank, so they require a collet or chuck that accepts that exact diameter.
How do I install the up/down compression cutters without damaging the flutes?
Insert the shank fully into the collet, tighten evenly, and set the plunge depth so the up-cut section clears chips before the down-cut engages the top surface.
When should I replace the tungsten steel cutters?
Replace them when the edges no longer shear wood, plywood or particleboard cleanly and the cutters start to burn or tear the material.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
