YINGHUA
YINGHUA 10 pieces 6X17X50MM Two Flutes UP And DOWN Cut Spiral Carbide Mill Cutters
Ten two-flute up-and-down spiral carbide mill cutters, 6×17×50 mm, for compression cutting wood and PVC on CNC machinery
- TypeRight-Angle Drills
- 10-piece set covers multiple CNC jobs
- Two-flute up-and-down spiral gives clean compression cuts
- 6 mm shank fits standard collets
- 17 mm cutting length handles thick stock
- Tungsten-steel body stays sharp in wood and PVC
10-Piece Tungsten-Steel Router Bit Set
This set contains ten two-flute up-and-down spiral carbide cutters sized 6×17×50 mm. They are made from tungsten steel for CNC milling of wood, plywood, density board, solid wood and particleboard. The compression geometry helps produce clean edges on both faces of the workpiece.
CNC Operators Cutting Wood And Sheet Materials
The bits suit hobbyists and small-shop users who need a ready supply of compression cutters for double-sided laminates or veneered panels. They are not for buyers who need metric shank sizes other than 6 mm, or for anyone machining metals, stone or glass.
Straightforward Collet Installation
Each cutter fits a 6 mm collet and installs like any straight-shank router bit. The only common issue is chipping if the feed rate is too high or the spindle speed is mismatched to the material. Keep the flutes clear of dust to avoid overheating.
Highlights
- 10-piece set covers multiple CNC jobs
- Two-flute up-and-down spiral gives clean compression cuts
- 6 mm shank fits standard collets
- 17 mm cutting length handles thick stock
- Tungsten-steel body stays sharp in wood and PVC
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What router or spindle collet size do these 6X17X50MM cutters require?
These cutters are 6X17X50MM; the first figure is the shank diameter, so your machine must accept a 6 mm shank.
Can I run these compression bits in a handheld drill for occasional wood or PVC cuts?
The specification lists the type as Right-Angle Drills, but compression spiral cutters are designed for rigid CNC routers; a handheld drill lacks the stiffness and speed control for clean cuts in wood, plywood or PVC.
How do I confirm the up-cut and down-cut flutes are both engaging cleanly after installation?
Inspect the cut edges on scrap material; a properly engaged compression cutter leaves a clean top surface from the down-cut section and a clean bottom surface from the up-cut section with no tear-out on either face.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
