YINGHUA
YINGHUA 10 pieces 6X12X50MM Two Flutes UP And DOWN Cut Spiral Carbide Mill Cutters
Set of 10 carbide spiral cutters with up-and-down flutes for clean compression cuts in wood and PVC
- TypeRight-Angle Drills
- 10-piece set covers multiple CNC jobs
- Up-down spiral geometry gives clean edges on wood and PVC
- Tungsten steel construction resists wear during heavy cutting
- 6 mm shank with 12 mm cut length suits standard collets
- Industrial-grade bits for plywood, density board and solid timber
CNC Router Bit Set — 10 Piece Pack
This set contains ten carbide spiral cutters designed for CNC machinery. Each cutter measures 6 mm shank by 12 mm cutting diameter by 50 mm overall length. The two-flute up-and-down geometry produces clean edges on both faces of the workpiece. They are suited for wood, plywood, density board, solid wood and particleboard.
Replaces Worn Single-Direction Bits
Up-and-down compression cutters replace standard up-cut or down-cut bits when tear-out on both surfaces is unacceptable. The upgrade is worth it for double-sided laminates, veneered panels or any job where flip-over sanding adds time. Single-flute or straight-flute tools cannot match the edge quality on the exit side.
Check Shank Fit And Machine Rigidity
Verify that your collet or tool holder accepts a 6 mm shank before ordering. The spindle must run true and the gantry must be stiff enough for carbide tooling at recommended feed rates. These cutters are rated for industrial use only and are not for anyone under 18 years of age.
Highlights
- 10-piece set covers multiple CNC jobs
- Up-down spiral geometry gives clean edges on wood and PVC
- Tungsten steel construction resists wear during heavy cutting
- 6 mm shank with 12 mm cut length suits standard collets
- Industrial-grade bits for plywood, density board and solid timber
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter do the 6X12X50MM carbide cutters need for my collet?
Each cutter has a 6 mm shank that matches a 6 mm collet on desktop CNC routers.
Which way do the two flutes cut when I mount the bit in the router?
The up-and-down spiral pulls chips both upward and downward, so feed direction stays the same as a standard straight bit.
When should I replace a cutter from the 10-piece set?
Replace a cutter when the tungsten-steel edges show visible rounding or when cuts in wood, plywood or particleboard start to tear out.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
