YINGHUA
YINGHUA 10-piece 3.175x15x38 mm two-flute up/down cut carbide end mill bits
Ten carbide end mills with up/down spirals cut wood, plywood and PVC cleanly in a CNC machine
- TypeRight-Angle Drills
- 10-piece set covers multiple CNC jobs
- 175 mm shank fits common collets
- 15 mm cutting length handles thick stock
- Up/down flutes compress fibres for clean edges
- Tungsten steel carbide resists wear in wood and PVC
10-piece carbide end mill set
This 10-piece set provides tungsten steel end mill bits for CNC routing tasks. Each cutter measures 3.175 mm shank diameter with 15 mm flute length and 38 mm overall length. The two-flute up/down compression geometry suits wood, plywood, density board, solid wood and particleboard. Industrial users gain a ready supply of identical cutters for production runs.
Sharp carbide edges reduce cutting force
Tungsten steel construction keeps edges sharp through repeated passes in abrasive sheet goods. The up/down flute design compresses chips toward the centre, limiting tear-out on both faces without extra hold-down pressure. Lower cutting forces mean less spindle load and quieter operation during extended profiling jobs.
Replaces worn single-flute or straight bits
Shops replacing dull single-flute cutters see cleaner edges and faster feed rates on the same toolpaths. The compression profile is not suited for plunge-only drilling or soft plastics that melt under chip compression. Buyers needing metric shank sizes other than 3.175 mm or flute lengths beyond 15 mm must source different tooling.
Highlights
- 10-piece set covers multiple CNC jobs
- 175 mm shank fits common collets
- 15 mm cutting length handles thick stock
- Up/down flutes compress fibres for clean edges
- Tungsten steel carbide resists wear in wood and PVC
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How do I install the 3.175 mm shank end mill in my CNC collet without vibration?
Use a collet or ER holder sized exactly for 3.175 mm, tighten the nut to the manufacturer torque spec, and check run-out with a dial indicator before cutting.
When should I replace the tungsten steel cutters after cutting wood and PVC?
Replace when the up/down flutes show visible rounding, chipping, or when cut quality on plywood and density board deteriorates despite correct feeds.
What limits continuous cutting depth with the 15 mm flute length on solid wood?
The 15 mm flute length limits axial depth per pass; deeper cuts require multiple passes to avoid tool deflection and overheating.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
