YINGHUA
YINGHUA 10 pcs 6×22×50 mm DLC Two-Flute Up-Down Spiral Carbide Mill Cutters
A 10-piece set of 6×22×50 mm DLC-coated carbide compression cutters for clean cuts in wood and PVC
- TypeRight-Angle Drills
- Ten-piece set covers multiple CNC jobs
- 6 mm shank fits standard collets
- 22 mm flute length reaches deep cuts
- 50 mm overall length clears thick stock
- DLC coating resists wear on wood and PVC
10-piece DLC-coated carbide set
This pack supplies ten 6×22×50 mm tungsten-steel cutters with a diamond-like carbon coating. The two-flute up-and-down spiral geometry suits CNC routing of wood, plywood, density board, solid wood and particleboard. Industrial users gain a ready-to-use replacement set for high-volume machining.
Sustained cutting in abrasive sheet goods
DLC coating reduces friction and heat buildup during long passes through particleboard and density board. The opposing flute directions compress chips toward the centre, limiting edge tear-out on both faces. Tungsten steel retains hardness through extended runs without frequent tool changes.
Replaces single uncoated compression bits
Shops swapping from bare carbide to this coated ten-pack see longer intervals between sharpening on composite panels. The upgrade pays off when daily output demands consistent finish quality on double-sided laminates. Not suited for metal, plastic welding or handheld drill use.
Highlights
- Ten-piece set covers multiple CNC jobs
- 6 mm shank fits standard collets
- 22 mm flute length reaches deep cuts
- 50 mm overall length clears thick stock
- DLC coating resists wear on wood and PVC
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How much heat or noise does the 6 mm shank cutter generate during continuous CNC operation?
The tungsten-steel body with DLC coating reduces friction, so the cutter runs cooler and quieter than uncoated bits when cutting wood, plywood or particleboard all day.
What collet or tool holder must I already own to fit the 6 mm shank on my CNC router?
You need a 6 mm ER collet or compatible 6 mm tool holder; the shank diameter is exactly 6 mm.
Will the up-down spiral geometry work reliably on the older density-board sheets I still have in stock?
Yes, the compression spiral cuts cleanly through density board and solid wood without tear-out on either face.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
