YIHUA 1200-TYPE-I 900M Soldering Iron Tips 5PCS 110W
Five 900M-series tips for 110 W YIHUA stations, excluding 948D, 928D-III, 938BD+-II, 939D+-III EVO, 982, 948DB+ II and 926LED-III models
- Watts110 watts
- Five tips included for extended use
- 110 W rating for demanding joints
- 900M series fits many YIHUA stations
- Incompatible with listed 948, 928, 938, 939, 982, 992, 926 models
- Verify model before ordering to ensure fit
What this set contains
The YIHUA 1200-TYPE-I package supplies five 900M series soldering iron tips rated at 110 watts. They are made for YIHUA soldering irons and stations that accept this tip series. The tips are new and ready for general electronics assembly or repair work.
Compatibility guide
These tips fit most YIHUA stations except the 948D, 928D-III, 938BD+-II, 939D+-III EVO, 982, 992, 926LED-III (110W, Red), 948DB+ II, 939D+ IV 300W and 928D-IV models. Buyers who own any of those stations should look for a different tip series. If the station model is unclear, verify compatibility before ordering.
Power rating and use
Each tip handles 110 watts, giving enough heat for typical through-hole and surface-mount joints on standard circuit boards. Heavy thermal loads such as large ground planes or thick connectors may exceed the tip's capacity. The 300 watt stations listed above require higher-rated tips not included in this set.
Highlights
- Five tips included for extended use
- 110 W rating for demanding joints
- 900M series fits many YIHUA stations
- Incompatible with listed 948, 928, 938, 939, 982, 992, 926 models
- Verify model before ordering to ensure fit
Specifications
| Watts | 110 watts |
|---|
Questions about this item
Which YIHUA soldering station do I need to already own so these 900M series tips will fit?
They fit YIHUA stations that accept 900M series tips, but they will not work with the 948D-III, 948DQ-III, 939D+ IV 300W, 928D-III, 938BD+-II, 939D+-III EVO, 982 Series, 992 Series, 928D-IV, 948DB+ II or 926LED-III (110W, Red) models.
If I keep my older YIHUA 939D+ station, will these 110W tips heat at the same rate?
The tips are rated at 110 watts, so they will only reach full power on a station that can supply 110 watts; an older 939D+ unit may limit the heating speed.
How can I confirm the 1200-TYPE-I tips are seated correctly after I install them?
After installation the tip should sit flush in the handle with no visible gap, and the station should display a stable temperature reading when the iron is powered on.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
