Xeno Energy
Xeno Energy XL-055F 3.6V 2/3 AA 1.65Ah Lithium Battery with Axial Leads 3-Pack
Pack of three 3.6 V 2/3 AA lithium cells with axial leads, 1.65 Ah capacity and a 10-year shelf life
- Battery Type2/3 AA
- Reliable power for a decade with 10+ year shelf life
- Consistent 3.6V output stable across most of the battery lifetime
- Ready for extreme environments from -55°C to +85°C
- Minimal self-discharge under 1% per year at 20°C storage
- Safe non-flammable inorganic electrolyte at ambient temperature
3-Pack 2/3 AA Lithium Cells
This pack contains three Xeno Energy XL-055F primary lithium batteries rated at 3.6 volts and 1.65 Ah each. They are built for devices that require the 2/3 AA form factor with axial leads for direct PCB mounting. Industrial and utility equipment needing long-term, maintenance-free power are the typical users.
Axial Lead Termination Style
The axial leads are the single specification that decides fit; they must match the through-hole spacing and solder pads on the target board. Verify the 14.5 mm maximum diameter and 33.5 mm maximum height against the battery compartment before ordering.
Solder Quickly and Observe Polarity
Solder the tabs in a few seconds to avoid heat damage to the internal electrolyte. The cells are not rechargeable, so never attempt to charge them. Do not mix with different battery models in series, and discard any unit with a mangled casing.
Highlights
- Reliable power for a decade with 10+ year shelf life
- Consistent 3.6V output stable across most of the battery lifetime
- Ready for extreme environments from -55°C to +85°C
- Minimal self-discharge under 1% per year at 20°C storage
- Safe non-flammable inorganic electrolyte at ambient temperature
Specifications
| Battery Type | 2/3 AA |
|---|
Questions about this item
What does the 1.65 Ah rating mean for runtime in a typical device?
At the recommended 60 mA continuous draw the cell delivers about 1.65 Ah before voltage falls off; higher loads reduce usable capacity.
What does the axial lead termination mean for installation?
Axial leads exit each end of the 14.5 mm diameter cylinder so the cell solders directly to a PCB or wires without a holder.
Will the 33.5 mm height fit my existing 2/3 AA compartment?
The maximum height is 33.5 mm and diameter 14.5 mm, matching the standard 2/3 AA form factor used in ER14335, SL-361 and TL-215 devices.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



