Xeno Energy
Xeno Energy XL-050F 3.6V 1/2 AA 1.2Ah Lithium Battery with Molex Connector
A 3.6V 1/2 AA lithium cell with a Molex connector delivers 1.2Ah capacity, 10+ year shelf life and stable voltage from -55°C to +85°C
- Battery Type1/2 AA Lithium
- 6 V high operating voltage stays stable through most of the battery life
- 2 Ah capacity among the highest nominal ratings available today
- Molex connector termination enables direct plug-in without soldering
- Shelf life exceeds 10 years with under 1 % annual self-discharge at 20 °C
- Operates reliably from -55 °C to +85 °C in humid conditions
Purpose & fit
The Xeno XL-050F is a 3.6 V 1/2 AA lithium primary cell rated at 1.2 Ah. It targets industrial equipment that demands a stable high voltage and very low self-discharge over many years. The Molex termination allows direct wiring into legacy sensor nodes, utility meters or security panels without soldering.
Sustained behaviour
The cell delivers a maximum continuous current of 30 mA and can supply 60 mA pulses. Voltage remains stable across most of the operating life from -55 °C to +85 °C. Shelf life exceeds 10 years with less than 1 % capacity loss per year at 20 °C. The inorganic electrolyte is non-flammable and non-pressurised at ambient temperature.
Install & pitfalls
The 14.5 mm diameter and 25.2 mm height match standard 1/2 AA compartments, and the Molex connector plugs straight into existing headers. Polarity must be observed; the battery is not rechargeable and any charging attempt will damage the cell. Store in a clean area to avoid corrosion of the corrosive electrolyte.
Highlights
- 6 V high operating voltage stays stable through most of the battery life
- 2 Ah capacity among the highest nominal ratings available today
- Molex connector termination enables direct plug-in without soldering
- Shelf life exceeds 10 years with under 1 % annual self-discharge at 20 °C
- Operates reliably from -55 °C to +85 °C in humid conditions
Specifications
| Battery Type | 1/2 AA Lithium |
|---|
Questions about this item
How much self-discharge does the Xeno XL-050F show after sitting at 20 °C for a year?
Less than 1 % capacity loss after one year of storage at 20 °C.
What connector must the target device provide for the Molex termination on this battery?
A matching Molex header with the same pin spacing and polarity as the battery lead.
Will the XL-050F replace a Saft LS-14250 in a legacy meter that runs at 3.6 V?
Yes, the XL-050F is listed as compatible with the Saft LS-14250 and shares the same 3.6 V nominal voltage.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



