We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Plastic transom mount multisensor with 30 foot cable and 10 pin connector

WUQ

WUQ 525STID-PWD Plastic Transom Mount 600W 10 pin Multisensor passive component

SKU CH-23JQ-Z78MH

Plastic transom-mount multisensor with temperature and removable speed assembly, 600 W power, 50/200 kHz frequencies, 45/11 degree beam angles, 30-foot cable and 10-pin connector

  • TypeOther
  • 600 W power handling for strong sonar returns
  • 50/200 kHz dual-frequency operation with 45/11° beam angles
  • 10-pin connector on 30 ft cable for simple installation
  • Plastic transom mount with temperature and removable speed assembly

WUQ 525STID-PWD 600W Multisensor Transducer

The WUQ 525STID-PWD is a plastic transom-mount multisensor designed for marine depth and temperature sensing. It operates at 600 watts across 50 and 200 kHz frequencies with beam angles of 45 and 11 degrees. A 30-foot cable with a 10-pin connector links the unit to compatible displays. The removable speed assembly simplifies maintenance and winterising.

Upgrading from lower-power

This transducer replaces basic 50 kHz or 200 kHz only units, adding dual-frequency coverage for both wide-area scanning and detailed bottom discrimination. The jump is worthwhile when you need simultaneous shallow and deep performance without swapping hardware. It is not for installations requiring through-hull mounting, bronze housings, or connector pin counts other than 10.

Highlights

  • 600 W power handling for strong sonar returns
  • 50/200 kHz dual-frequency operation with 45/11° beam angles
  • 10-pin connector on 30 ft cable for simple installation
  • Plastic transom mount with temperature and removable speed assembly

Specifications

TypeOther

Questions about this item

What transom thickness and mounting hardware does the 525STID-PWD plastic transom mount require?

The 525STID-PWD mounts on a transom using the supplied plastic bracket and stainless-steel screws; no through-hull cut-out is needed.

How is the 10-pin connector wired during installation, and what step is often missed?

Route the 30-foot cable to the sounder, align the keyed 10-pin plug, seat it fully until the latch clicks, then secure the removable speed assembly — skipping the latch causes intermittent data.

More in Passive Components

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.