Westward
Westward 5VPC3 118° .3750 Carbide Jobber Drill Bit
Carbide jobber drill bit with a 118-degree conventional point for .3750-inch holes
- TypeAngle, Pitch & Slope Locators
- Carbide construction resists wear for longer tool life
- 118 degree point angle centres quickly on contact
- .3750 decimal size matches 3/8 inch fractional spec
- Jobber length provides standard reach for general drilling
- Bright uncoated finish suits non-ferrous and low-alloy materials
Purpose & Audience
The Westward 5VPC3 is a jobber length drill bit made from carbide with a conventional 118 degree point. It suits machinists and maintenance crews who need a rigid tool for drilling abrasive or non-ferrous materials.
Interface Limits
The 118 degree point angle is a general-purpose geometry that centres quickly in softer stock but can wander on hardened steel without a pilot hole. Carbide construction resists wear far longer than high-speed steel yet remains brittle, so heavy feed rates or interrupted cuts risk chipping the cutting edges.
Installation & Pitfalls
The bit fits any standard 3/8 inch drill chuck and requires no special holders or coolant-through spindles. Common problems include premature breakage when the workpiece moves, excessive heat buildup in deep holes without peck drilling, and rapid dulling if used on ferrous alloys that exceed the material’s recommended hardness range.
Highlights
- Carbide construction resists wear for longer tool life
- 118 degree point angle centres quickly on contact
- .3750 decimal size matches 3/8 inch fractional spec
- Jobber length provides standard reach for general drilling
- Bright uncoated finish suits non-ferrous and low-alloy materials
Specifications
| Brand | Westward |
|---|---|
| Type | Angle, Pitch & Slope Locators |
Questions about this item
Should I choose the 118 degree point angle or a different angle for this drill bit?
The 118 degree point angle is a general-purpose geometry suited for drilling mild steel, aluminium and plastic in a handheld or press drill.
What does the .3750 decimal equivalent mean when the bit is in the chuck?
.3750 is the exact diameter in inches, so the bit cuts a 3/8 inch hole without oversize or undersize deviation.
How does the jobber length and carbide material affect drilling depth and speed?
Jobber length gives a standard flute and overall length for typical bench drilling, while carbide allows higher cutting speeds and longer edge life in abrasive materials.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
