Westward
Westward 5PXH0 Pipe Tap 1/8"-27 Semi-Bottoming 4 Flutes NPT
Cuts NPT threads in 1/8"-27 pipe with a semi-bottoming, four-flute high-speed steel design
- TypeHole, Drill, Bore & Wire Gauges
- NPT threads for leak-tight pipe joints
- Semi-bottoming design taps close to blind-hole bottom
- Four flutes clear chips efficiently during cutting
- High-speed steel resists wear on repeated use
- Right-hand cut matches standard pipe threading
Pipe tap for 1/8"-27 NPT threads
This Westward pipe tap cuts internal NPT threads sized 1/8 inch with 27 threads per inch. It is intended for mechanics, plumbers and maintenance technicians who need to create or repair tapered pipe threads in metal fittings. The semi-bottoming design allows threading close to the bottom of a blind hole. Four flutes help evacuate chips during the cut.
High-speed steel construction with bright finish
The tap is made from high-speed steel and has a bright, uncoated surface. Right-hand cutting direction follows standard practice for NPT pipe threads. Thread length measures three-quarters of an inch within an overall length of two and one-eighth inches. A 75 percent thread drill size Q is specified for the tapping drill, and the class of fit is 3B.
Manual operation with standard tap wrench
In normal hand-tapping use the tool generates minimal heat because cutting speed is low and lubrication is applied by the operator. Noise is limited to the sound of the tap turning in the workpiece. No external power is required, so power draw is not a factor. Chip clearance through the four flutes reduces binding risk during the cut.
Highlights
- NPT threads for leak-tight pipe joints
- Semi-bottoming design taps close to blind-hole bottom
- Four flutes clear chips efficiently during cutting
- High-speed steel resists wear on repeated use
- Right-hand cut matches standard pipe threading
Specifications
| Brand | Westward |
|---|---|
| Type | Hole, Drill, Bore & Wire Gauges |
Questions about this item
What thread standard does the 1/8"-27 NPT tap cut?
It cuts National Pipe Taper threads to a Class 3B fit for pressure-tight joints.
What shank and square dimensions does the tap need in a holder?
The tap follows standard NPT shank dimensions for 1/8" size; use a matching tap wrench or holder.
Which drill size should be used before tapping with this tool?
Drill with a size Q bit to achieve the recommended 75 percent thread engagement.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
