Westward
Westward 5MW41 Straight Metal Cutting Snip 11 1/2 in Alloy Steel
Straight-cut alloy-steel snip with serrated edge for clean metal cutting
- TypeKnives, Cutters & Snips
- Weight1.05
- Straight cutting action simplifies sheet-metal trimming
- Serrated edges grip material to prevent slipping
- Alloy-steel blades resist wear during repeated cuts
- 3 in cutting length handles common gauge stock
- Lightweight 1.05 lb design reduces hand fatigue
Straight Metal Cutting Snip 11 1/2 in
The Westward 5MW41 is a straight-cutting hand snip built for tradespeople who need clean, linear cuts in sheet metal. Its alloy steel blades handle the material without requiring powered equipment, making it practical for on-site fabrication, ductwork adjustments and general metalworking tasks where a straight line is the priority.
Sustained cutting performance
The serrated cutting edge grips the workpiece to reduce slippage during repeated cuts, helping maintain control through longer sessions. A 3 in cutting length lets each stroke remove a useful amount of material, while the alloy steel construction resists edge deformation so the tool keeps cutting cleanly without frequent resharpening or blade changes.
Alloy steel build and daily use
At 1.05 weight units the snip feels substantial in hand without causing rapid fatigue during overhead or repetitive work. The straight blade orientation suits right-angle trimming and flat-pattern layout, though it will not follow tight curves or circles. California Proposition 65 warnings apply, so users should observe appropriate handling and hygiene practices in the workshop.
Highlights
- Straight cutting action simplifies sheet-metal trimming
- Serrated edges grip material to prevent slipping
- Alloy-steel blades resist wear during repeated cuts
- 3 in cutting length handles common gauge stock
- Lightweight 1.05 lb design reduces hand fatigue
Specifications
| Brand | Westward |
|---|---|
| Type | Knives, Cutters & Snips |
| Weight | 1.05 |
Questions about this item
How much effort does the 1.05 lb alloy steel body require during a full day of straight cuts?
The 1.05 lb alloy steel snip keeps hand fatigue low during extended straight cutting sessions.
What personal protective equipment must I already own before using the 5MW41 snip?
Wear cut-resistant gloves and safety glasses; the serrated edge and Proposition 65 warning demand both.
Will the 3 in serrated blade on the 5MW41 damage the finish on older aluminium trim I want to keep?
The serrated 3 in blade grips sheet metal cleanly but can mark softer aluminium if not supported.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
