Westward
Westward 54PR10 wobble socket extension 1/2 inch drive 10 inch
A 10-inch alloy-steel wobble extension lets a 1/2-inch drive socket reach around obstructions at angles up to 54 degrees
- Typesocket
- 1/2 inch drive fits standard sockets
- 10 inch length reaches deep fasteners
- Wobble design angles around obstructions
- Alloy steel construction resists wear
- Chrome finish protects against corrosion
10-inch 1/2" drive wobble extension
The Westward 54PR10 is a 10-inch socket extension with a 1/2-inch square drive on both ends. Its wobble design lets the socket pivot off-centre so you can reach fasteners that are not perfectly aligned with the drive. The alloy-steel body carries a chrome finish for corrosion resistance.
Replaces fixed extensions in tight spots
A fixed extension forces the socket to stay in line with the ratchet, which can make angled bolts impossible to engage. The wobble joint on this tool adds the angular freedom needed to seat the socket on offset fasteners without removing surrounding components. The upgrade is worth it whenever a straight extension cannot make the connection.
Fits standard 1/2-inch drive sets
The extension accepts any 1/2-inch drive socket and locks onto any 1/2-inch drive ratchet or breaker bar. It adds 10 inches of reach while the wobble action clears obstructions that would block a straight tool. No special sockets or adapters are required beyond the standard 1/2-inch square-drive ecosystem.
Highlights
- 1/2 inch drive fits standard sockets
- 10 inch length reaches deep fasteners
- Wobble design angles around obstructions
- Alloy steel construction resists wear
- Chrome finish protects against corrosion
Specifications
| Brand | WESTWARD |
|---|---|
| Type | socket |
Questions about this item
Will the 10 in extension reach past the brake caliper on a 1/2 in drive ratchet?
The 10 in overall length adds reach for deep fasteners while keeping the 1/2 in square drive engaged
Does the wobble joint lock straight or stay flexible during torque?
The wobble design allows angular movement; it does not lock into a rigid straight position
Will the chrome finish on the alloy steel body resist shop chemicals?
Chrome plating on alloy steel resists common solvents and corrosion under normal use
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
