Westward
Westward 3CYV4 Spiral Ratchet Pipe Reamer 1/4 to 2 Inch
Spiral ratchet pipe reamer handles 1/4 to 2 inch copper, PVC and steel pipe for countersinking and deburring
- TypeAngle, Pitch & Slope Locators
- Spiral ratchet action speeds up reaming tasks
- Self-feeding blade design reduces operator effort
- Handles pipe sizes from 1/4 to 2 inches
- Works on copper, PVC and steel materials
- Performs countersinking and deburring in one tool
Spiral Ratchet Pipe Reamer 1/4-2 Inch
The Westward 3CYV4 is a hand-operated pipe reamer built for countersinking and deburring the inner edges of conduit and tubing. Its self-feeding spiral blade advances smoothly through copper, PVC and steel pipe from a quarter inch up to two inches in diameter. Plumbers, electricians and maintenance crews reach for it when clean, burr-free ends are required before joining or threading.
Fits a tool bag, not a bench
At twenty-one and a half inches long and two and a half inches wide the reamer slides into a standard kit alongside wrenches and cutters. The straight steel handle gives direct leverage without needing a separate ratchet or power drive, freeing up bench space and removing the hunt for batteries or sockets on the job site.
Steady cutting through thick wall
The blade handles pipe walls up to four millimetres thick, maintaining a consistent feed rate during extended use on steel conduit. Heat buildup stays low because the cutting action is spread along the spiral, so the tool keeps producing clean chamfers across long runs without the grab-and-release cycle common with single-flute reamers.
Highlights
- Spiral ratchet action speeds up reaming tasks
- Self-feeding blade design reduces operator effort
- Handles pipe sizes from 1/4 to 2 inches
- Works on copper, PVC and steel materials
- Performs countersinking and deburring in one tool
Specifications
| Brand | Westward |
|---|---|
| Type | Angle, Pitch & Slope Locators |
Questions about this item
How much wall thickness can the reamer handle before the blade stops feeding?
The self-feeding blade is rated for pipe walls up to 4 mm thick.
Does the straight steel handle transmit vibration during long conduit runs?
The all-steel construction transfers cutting vibration directly to the operator’s hand.
What pipe sizes must already be on site for the 1/4 to 2 inch range to be useful?
You need copper, PVC or steel pipe with an inner diameter between 1/4 and 2 inches.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
