Westward
Westward 3CYT1 tube cutter 1/8–1 1/8 in
Cuts aluminium, brass and thin-walled copper tubing from 1/8 to 1 1/8 in with an enclosed feed wheel and grooved rollers for close-to-flare cuts
- TypeAngle, Pitch & Slope Locators
- Compact 6 1/2 in length fits tight spaces
- Cuts 1/8–1 1/8 in aluminium, brass, copper
- Enclosed feed wheel gives clean, square cuts
- Grooved rollers allow cutting close to flared ends
- Spare copper cutting wheel included for quick replacement
Compact tube cutter for tight spaces
The Westward 3CYT1 midget tube cutter handles aluminium, brass and thin-walled copper from 1/8 in to 1 1/8 in. Its short 6 1/2 in length and 56 mm width let it work where full-size cutters cannot reach. Grooved rollers allow cuts close to flares without damaging the fitting. A spare cutting wheel for copper is included.
Zinc body with enclosed feed mechanism
The zinc frame resists corrosion while the enclosed feed wheel keeps the cutting action smooth and protected from debris. At 183 mm tall the tool sits low in the hand, reducing knuckle clearance issues on crowded pipe runs. No reaming tool is integrated so a separate deburrer is needed for finished ends. The cutter is not tether-ready for drop-prevention systems.
Replaces bulky cutters on small-bore work
Swapping a standard cutter for this model saves time when multiple cuts are needed on 1/8–1 1/8 in tubing in confined areas. The jump is worth it if you regularly cut near flares or in panels where a longer handle cannot rotate. Buyers who need larger diameter capacity or an integrated reamer should look elsewhere.
Highlights
- Compact 6 1/2 in length fits tight spaces
- Cuts 1/8–1 1/8 in aluminium, brass, copper
- Enclosed feed wheel gives clean, square cuts
- Grooved rollers allow cutting close to flared ends
- Spare copper cutting wheel included for quick replacement
Specifications
| Brand | Westward |
|---|---|
| Type | Angle, Pitch & Slope Locators |
Questions about this item
What is the maximum tube diameter the Westward 3CYT1 can cut?
The Westward 3CYT1 cuts tubing up to 1 1/8 in diameter using its enclosed feed standard wheel cutter.
What are the tool dimensions for fitting the Westward 3CYT1 in a toolbox?
The cutter measures 6 1/2 in long, 183 mm high and 56 mm wide with a zinc body.
How do I install the spare cutting wheel on the Westward 3CYT1?
Remove the retaining pin, swap the standard wheel for the included copper spare, then re-secure the pin so the wheel rotates freely.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
