Westward
Westward 2LWT4 Straight Flute Hand Tap M18x1.50 Taper 4 Flutes
Cuts M18×1.5 metric fine threads with a taper lead and four straight flutes in high-speed steel
- TypeHole, Drill, Bore & Wire Gauges
- M18×1.50 fine thread fits precision metric applications
- Taper chamfer eases starting in through or blind holes
- Four straight flutes clear chips for smoother cutting
- High-speed steel construction resists wear during repeated use
- Bright uncoated finish suits general-purpose threading tasks
Thread Cutting Tool for M18x1.5 Holes
This Westward straight flute hand tap cuts internal threads in an M18 by 1.50 metric fine size. It is made from high speed steel with a bright uncoated finish and has four flutes. The taper chamfer helps start the thread cleanly in a pre-drilled hole. Right hand rotation suits standard threading applications.
Fits Standard Tap Wrenches and Drilled Holes
The tap has an overall length of 4 1/32 in and a thread length of 1 13/16 in, matching common tool holders. A D7 thread limit provides the correct class of fit for general purpose work. You supply the tap wrench, the correctly sized drill bit and cutting fluid. The tool frees you from needing a powered tapping head for one-off or repair jobs.
Steady Cutting Action in Deep Holes
Four flutes give a stable cut and good chip clearance when the tap reaches full depth. High speed steel retains hardness during sustained hand turning better than carbon steel alternatives. The taper lead reduces the torque spike at the start of each new hole. Uncooted surfaces are easy to inspect for wear between uses.
Highlights
- M18×1.50 fine thread fits precision metric applications
- Taper chamfer eases starting in through or blind holes
- Four straight flutes clear chips for smoother cutting
- High-speed steel construction resists wear during repeated use
- Bright uncoated finish suits general-purpose threading tasks
Specifications
| Brand | Westward |
|---|---|
| Type | Hole, Drill, Bore & Wire Gauges |
Questions about this item
How deep can the M18x1.50 tap cut threads in a single pass?
The thread length is 1 13/16 in so each pass cuts threads up to that depth before you must reverse the tap.
Does the high-speed steel tap run hot enough to need coolant during long sessions?
High-speed steel generates noticeable heat in continuous use; apply cutting oil to control temperature and extend tool life.
What size tap wrench or handle fits the 4-flute shank?
Use a standard tap wrench that accepts a 13/16 in square drive to turn the tap safely.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
