Westward
Westward 22UV64 2-Cutter Hammer Drill Bit 3/8" 12" SDS Plus
A 2-cutter SDS Plus hammer drill bit with a 3/8 inch carbide tip for masonry, 12 inches long and drilling to 10 inches depth
- Drills to 10 in depth in masonry
- 12 in overall length reaches through thick material
- 2-cutter carbide tip cuts clean holes
- SDS Plus shank fits rotary hammer drills
- Bright uncoated finish resists corrosion in use
Westward 22UV64 SDS Plus Bit
The Westward 22UV64 is a two-cutter hammer drill bit built for masonry work. It uses an SDS Plus shank to fit rotary hammers with that chuck type. The 3/8 inch diameter suits anchor and fastener holes in concrete, brick or block. It is sold new for professional and serious DIY use.
Fits SDS Plus Rotary Hammers
The bit locks into an SDS Plus chuck without a separate chuck key, so tool changes stay fast on site. Its 12 inch overall length and 10 inch maximum drilling depth let you reach through thick walls or deep embedments. The straight flute clears dust while the carbide tip does the cutting.
Replaces Worn 3/8 Inch SDS Bits
When an existing 3/8 inch SDS Plus bit dulls or chips, this bit restores drilling speed and hole accuracy. The jump is worth it if your current bit struggles to reach 10 inch depth or if the tip geometry has worn past resharpening. It does not suit hex-shank drills or larger SDS Max machines.
Highlights
- Drills to 10 in depth in masonry
- 12 in overall length reaches through thick material
- 2-cutter carbide tip cuts clean holes
- SDS Plus shank fits rotary hammer drills
- Bright uncoated finish resists corrosion in use
Specifications
| Brand | WESTWARD |
|---|
Questions about this item
How deep can the 12 in bit drill into masonry before hitting its limit?
The maximum drilling depth is 10 in, so sustained use stops at that point.
Does the carbide tip run hot or draw extra power during all-day drilling?
The bright uncoated carbide tip cuts cleanly without added coatings that trap heat.
Which rotary hammer chuck accepts the 25/64 in SDS Plus shank on this bit?
Any SDS Plus rotary hammer accepts the 25/64 in shank for immediate use.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
