Westward
Westward 21EM19 Grease Gun Swivel 90 Deg 1/4 In fluid
A 90-degree grease gun swivel with a 1/4 inch outlet for high-pressure lubrication
- 90-degree swivel eases access in tight spots
- 6,000 psi rating handles high-pressure lubrication tasks
- 1/4-inch FNPT outlet fits standard grease gun fittings
- White zinc-plated steel resists corrosion in workshop environments
- Buna-N and PTFE seals compatible with common greases
Grease Gun Swivel 90 Deg
The Westward 21EM19 grease gun swivel connects a 1/2 in UNF inlet to a 1/4 in FNPT outlet. It is built for technicians who need a 90-degree rotation on grease dispensing equipment. The white zinc plated finish adds corrosion resistance in shop environments. Wetted materials include Buna-N, PTFE and steel.
Thermals Noise and Power Draw
This component has no electrical or thermal load because it is a passive fluid fitting. It does not generate heat, consume power or produce audible noise during normal operation. Maximum operating pressure is rated at 6,000 psi for grease media. Performance depends on the supply system rather than the swivel itself.
Upgrade and Replacement Context
The swivel replaces a fixed straight connector when hose routing requires a right-angle turn at the gun. It is not suited for applications that need a straight in-line coupling or a different thread combination. Buyers who want a swivel with another inlet or outlet size should look for a different part number.
Highlights
- 90-degree swivel eases access in tight spots
- 6,000 psi rating handles high-pressure lubrication tasks
- 1/4-inch FNPT outlet fits standard grease gun fittings
- White zinc-plated steel resists corrosion in workshop environments
- Buna-N and PTFE seals compatible with common greases
Specifications
| Brand | WESTWARD |
|---|
Questions about this item
How do I install the 90-degree swivel onto a 1/2 in UNF inlet without cross-threading the 1/4 in FNPT outlet?
Screw the 1/2 in UNF end into the grease gun first, using a wrench on the steel body only. Then attach the hose to the 1/4 in FNPT outlet. Do not force the PTFE seal; hand-tighten plus one-half turn seats it correctly.
Which wetted materials will need inspection or replacement after extended grease exposure?
The Buna-N and PTFE seals inside the swivel body are the wear items. Inspect them during routine grease-gun servicing; replace if they show cracking, flattening or grease weeping past the 90-degree joint.
At what pressure does the 6,000 psi rating become the limiting factor during continuous pumping?
The 6,000 psi maximum operating pressure is the first limit reached under sustained high-volume use. Exceeding it risks permanent deformation of the steel housing and seal extrusion, so keep system pressure below that threshold.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
