Dayton 13E670 AC line switch kit for models 13E650 13E651 13E654 13E655
- 5.100
- Building Cable
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Westward
Red 6-gauge copper battery cable, 25 ft long with TPR insulation, rated for 37 amps and 60 volts up to 150 °F
This 25 ft red battery cable is built for automotive and industrial power connections. It uses 6 gauge copper conductors rated for up to 37 amps and 60 volts. The TPR insulation withstands temperatures up to 150 degrees F. It meets SAE J1127 standards for reliable performance.
The cable carries up to 37 amps continuously with minimal voltage drop across its 25 ft length. Copper conductors keep resistance low so heat stays within the 150 degree F rating under normal loads. No active cooling or moving parts means completely silent operation. Power loss depends only on the current drawn by the connected equipment.
The 25 ft length gives flexibility for routing between batteries, starters or distribution blocks in large vehicles or equipment. Red TPR jacket identifies the positive lead at a glance and resists oil, abrasion and weather. No connectors are included so you terminate with lugs or clamps that match your application. California Proposition 65 warnings apply to chemicals in the insulation.
No published specifications for this item yet.
Route the 25 ft cable from the battery terminal to the starter or accessory, crimp or solder a proper 6 ga lug onto the copper conductor, then torque the terminal bolt to the vehicle specification; the step most often missed is removing every strand of the TPR insulation before crimping so the lug seats fully on bare copper.
Inspect the TPR jacket annually for cracks, abrasion or oil swelling; if the insulation is damaged or the copper strands show corrosion at the lug, replace the entire 25 ft run because the SAE J1127 rating covers the assembly, not a field repair.
The 37 amp continuous rating is reached before the 60 V or 150 °F limits, so sustained loads above 37 amps will overheat the 6 ga copper conductor first.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?