Weiler
Weiler ME-982 Miniature End Brush 5/16in Dia Stainless Steel
Miniature stainless-steel end brush with 5/16 in diameter for precision deburring and blending
- TypeOther
- Precision cleaning with stainless-steel bristles
- 5/16-inch diameter reaches tight spaces
- 1/8-inch shank fits die grinders and flexible shafts
- Lightweight at 0.02 pounds for controlled detail work
- Suited for light deburring and precision finishing
Precision miniature end brush
The Weiler ME-982 is a stem-mounted miniature end brush built for detail work in tight spaces. It suits technicians in aerospace, dental, optics, electronics and jewellery who need controlled material removal on small components. The 5/16 inch stainless steel brush diameter targets light deburring and blending of surface junctures. It mounts on flexible shaft tools or die grinders via a 1/8 inch shank.
Thermals and power draw
As an unpowered accessory the brush generates no heat and draws no electricity during use. Operational noise comes only from the host tool and the cutting action on the workpiece. There is no internal motor, bearing or fan to add thermal load or acoustic signature. The stainless steel bristles resist corrosion without requiring lubrication or cooling.
Build integration
The 1/8 inch shank fits standard collets on flexible shaft machines and die grinders, so no adapter is needed. At 0.02 pounds the brush adds negligible mass to the tool nose, preserving balance for fine control. Its compact envelope reaches confined features that larger cup or wheel brushes cannot access. The single-unit sale pack lets workshops stock only the quantity required for each job.
Highlights
- Precision cleaning with stainless-steel bristles
- 5/16-inch diameter reaches tight spaces
- 1/8-inch shank fits die grinders and flexible shafts
- Lightweight at 0.02 pounds for controlled detail work
- Suited for light deburring and precision finishing
Specifications
| Type | Other |
|---|
Questions about this item
How do I install the 1/8 in stem into a die grinder collet without it slipping?
Insert the stem fully into the collet and tighten evenly; the step people miss is cleaning any oil from the shank before clamping so the 1/8 in diameter seats securely.
When will the stainless steel bristles need replacement?
Replace the brush once the 5/16 in diameter bristles wear down enough that they no longer contact the workpiece during light deburring or blending tasks.
What limit appears first during sustained high-speed use?
The 0.02 lb brush can overheat at the stem-to-bristle joint if run continuously beyond the tool maker's recommended duty cycle for miniature mounted brushes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
