Weiler
Weiler 10015 Crimped Wire End Brush Stainless Steel 0.014 in 25000 RPM
Crimped stainless-steel end brush with 0.014 in wire for 25000 RPM grinders and drills
- TypeSanders
- Stainless steel bristles resist corrosion on stainless workpieces
- Crimped wire design cleans and deburrs without gouging
- 014 in wire diameter suits fine surface preparation
- 1/4 in round shank fits drills and straight grinders
- Rated 25 000 RPM for high-speed power tools
Crimped stainless-steel end brush
The Weiler 10015 is a crimped-wire end brush made from stainless steel for use with straight grinders, drills, impact drivers and pencil grinders. A 1/4 in round shank fits standard collets and the brush runs at up to 25,000 RPM. The 1/2 in diameter head carries 0.014 in wire with a 7/8 in trim length for light deburring and cleaning tasks.
Metalworkers needing non-contaminating surface prep
Suited for technicians who need a stainless-steel brush that will not contaminate corrosion-resistant alloys during weld cleaning or scale removal. The fine 0.014 in wire and crimped construction limit aggression on thin sheet or delicate edges. Not suited for buyers who need heavier material removal on thick steel or who require a brush for high-volume automated equipment.
25,000 RPM maximum operating speed
The brush is rated for a maximum free speed of 25,000 RPM on the tool spindle. Running it faster than this rating risks wire breakage and loss of bristles, so the tool speed must be confirmed before use. This single speed limit determines whether the brush matches the grinder or drill being used.
Highlights
- Stainless steel bristles resist corrosion on stainless workpieces
- Crimped wire design cleans and deburrs without gouging
- 014 in wire diameter suits fine surface preparation
- 1/4 in round shank fits drills and straight grinders
- Rated 25 000 RPM for high-speed power tools
Specifications
| Type | Sanders |
|---|---|
| Brand | Weiler |
| Model | 10015 |
Questions about this item
How often will the 0.014 in stainless steel crimped wire bristles need replacing on this 10015 end brush?
The crimped stainless steel wire bristles wear down with use; replace the brush when the 7/8 in bristle length shortens noticeably or the 1/2 in brush diameter loses its cleaning aggression.
What is the first limit reached when running this 10015 end brush continuously at 25,000 RPM?
The 25,000 RPM maximum operating speed is the hard limit; exceeding it risks wire breakage and unsafe operation on any compatible straight grinder, drill, impact driver or pencil grinder.
How much heat and vibration does the 1/4 in round shank transmit during all-day use of this 10015 end brush?
The 5/8 in shank length and 1/4 in round shank design transmit moderate vibration; heat build-up stays low because stainless steel bristles generate less friction than abrasive discs.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
