WAWEIS
WAWEIS 19.5V 6.15A AC Adapter for ACDP-120N01 ACDP-120N02 ACDP-120E01 ACDP-120E02
A 19.5V 6.15A replacement AC adapter with a 10 ft power cord and over-current, over-voltage and short-circuit protection, compatible with ACDP-120 series chargers
- Worldwide 100-240VAC 50/60Hz input works anywhere
- 10 ft power cord gives flexible placement
- Over current, over voltage, short circuit and total power protection safeguards hardware
- FCC, CE and RoHS certified for safety compliance
- 100% compatible with listed Sony VAIO and PCG models
Compatible replacement adapter
The WAWEIS 19.5V 6.15A AC adapter replaces the ACDP-120N01, ACDP-120N02, ACDP-120E01 and ACDP-120E02 power supplies. It supports Sony Vaio models VGN-AR760U, VGN-AR840E, PCG-8111L and PCG-8112L. The unit delivers 19.5VDC at 6.15A with a 100-240VAC 50/60Hz world-wide input range.
Thermal and safety protections
Over-current protection, over-voltage protection, short-circuit protection and total power protection guard the charger during normal operation. Overload protection uses high-quality wires while overheating protection relies on a smart chip. Anti-interference isolation materials further reduce electrical noise. The adapter carries FCC, CE and RoHS certifications.
Sustained-load behaviour
The 10 ft power cord provides reach for desk or floor outlets during extended sessions. A 12 month warranty covers the new components, which are tested under strict quality-control standards. The supply is guaranteed to meet the original device specifications for continuous compatibility.
Highlights
- Worldwide 100-240VAC 50/60Hz input works anywhere
- 10 ft power cord gives flexible placement
- Over current, over voltage, short circuit and total power protection safeguards hardware
- FCC, CE and RoHS certified for safety compliance
- 100% compatible with listed Sony VAIO and PCG models
Specifications
No published specifications for this item yet.
Questions about this item
How do I install the WAWEIS 19.5V 6.15A adapter and what is the step people often miss?
Plug the 10 ft cord into a 100-240VAC 50/60Hz outlet then connect the barrel tip to the laptop; the step often missed is verifying the laptop requires 19.5VDC at 6.15A before powering on.
What maintenance or replacement will this WAWEIS charger need over time?
The 10 ft power cord and barrel connector can wear from repeated bending; inspect them periodically and replace the unit if the cable sheath frays or the tip becomes loose.
What limit appears first when the WAWEIS adapter runs continuously at full load?
The 120 W output ceiling (19.5V × 6.15A) is reached first; sustained loads at that level trigger the built-in over-current and over-temperature protections.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



