WAWEIS
WAWEIS 12V AC Adapter 100-240VAC 50/60Hz 6.5 Ft Cord FCC CE RoHS
A 12 V AC adapter with 100-240 VAC input, 6.5 ft cord and FCC, CE, RoHS certification
- World-wide 100-240 VAC input works across regions
- 5 ft total cord length gives flexible placement
- FCC, CE and RoHS certifications confirm safety compliance
- Over-current, over-voltage and short-circuit protections guard equipment
- 100 % compatible replacement for listed Speco camera models
Replacement AC Adapter for Speco Cameras
This 12 V AC/DC adapter replaces the original power supply for Speco Technologies PSW-5, PSW5, CVC-627M, CVC-562SD, HT-INTB9, HT-INTB8 and HTINTD8 surveillance cameras. It accepts a world-wide input of 100-240 VAC at 50/60 Hz and delivers 12 VDC at up to 1 A. The unit ships new with a 6.5 ft power cord and carries FCC, CE and RoHS certifications.
Upgrade from a Failed or Lost OEM Charger
The adapter is a direct replacement when the factory-supplied charger is damaged, lost or no longer holds a stable 500 mA to 1000 mA output. Built-in over-current, over-voltage, short-circuit and total-power protection guard the camera against mains irregularities. A smart chip adds over-temperature and anti-interference safeguards for continuous 24/7 operation.
12 VDC Output with 1 A Headroom
The supply comfortably powers cameras rated for 0.5 A or 1 A draw, leaving margin for brief start-up surges. It will not support devices that require more than 1 A at 12 V or any non-12 V equipment. The fixed 6.5 ft cord limits placement to outlets within that reach unless an approved extension is used.
Highlights
- World-wide 100-240 VAC input works across regions
- 5 ft total cord length gives flexible placement
- FCC, CE and RoHS certifications confirm safety compliance
- Over-current, over-voltage and short-circuit protections guard equipment
- 100 % compatible replacement for listed Speco camera models
Specifications
No published specifications for this item yet.
Questions about this item
What DC connector size does this 12V adapter use for the Speco cameras?
The adapter terminates in a standard barrel plug that matches the Speco PSW-5, CVC-627M and HT-INTB series cameras; the centre-positive tip fits the 12VDC input on those models.
How do I connect the 6.5 ft cord without damaging the surveillance unit?
Plug the IEC-end into a 100-240VAC 50/60Hz mains socket first, then insert the DC barrel into the camera; reversing the order can trigger the short-circuit protection.
When should I replace the power supply if the camera shows intermittent video loss?
If the green LED on the brick flickers or the unit feels hot after 24 hours of continuous 500mA to 1000mA draw, the internal smart-chip protection has likely degraded and the adapter should be swapped.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



