We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two short black USB-A cables with four bare wires exposed

Vszerda

Vszerda USB A Male to 4 Pin Bare Wire 11inch 22AWG 480 Mbps 2-Pack

SKU CH-Y9HS-4DHD1

Two 11-inch USB-A male to four-pin bare-wire pigtails with 22 AWG copper cores for 5 V 3 A charging and 480 Mbps data

  • TypeUSB
  • Connector TypeUSB Type A
  • ColorBlack
  • Connector Number4
  • Connector DetailUSB Type A
  • Terminal GenderMale-to-Male
  • USB A male to bare 4-pin wire for DIY repair
  • 22AWG copper cores carry 5V 3A power and 480 Mbps data
  • Colour-coded leads simplify soldering to USB devices
  • 11 inch length fits tight enclosures and prototypes
  • Two cables included for spare or parallel projects

USB A male to bare-wire cable

This 2-pack provides USB Type A male plugs on one end and four colour-coded bare wires on the other. Each cable measures 30 cm (11 inches) and uses 22 AWG all-copper conductors inside a black PVC jacket. The pinout follows the standard USB scheme: red for 5 V power, black for ground, white for data minus and green for data plus.

DIY repair and low-power device builders

Makers who need to add a USB power or data connection to custom boards, LED lamps, small fans or similar 5 V 3 A equipment will find the pre-tinned tails convenient for soldering or screw terminals. Anyone requiring a finished connector such as Micro-USB, USB-C or a proprietary plug should look elsewhere, as this cable terminates in bare wire only.

480 Mbps data and 3 A charging headroom

The link supports USB 2.0 signalling at 480 Mbps, adequate for keyboards, mice, sensors or firmware updates on low-power gear. The 22 AWG copper cores carry the rated 3 A for charging phones, tablets or power banks, but the 30 cm length leaves no slack for routing around larger enclosures or distant ports.

Highlights

  • USB A male to bare 4-pin wire for DIY repair
  • 22AWG copper cores carry 5V 3A power and 480 Mbps data
  • Colour-coded leads simplify soldering to USB devices
  • 11 inch length fits tight enclosures and prototypes
  • Two cables included for spare or parallel projects

Specifications

BrandMaixbomr
TypeUSB
Connector TypeUSB Type A
ColorBlack
Connector Number4
Connector DetailUSB Type A
Terminal GenderMale-to-Male
Speed480 megabits_per_second
ConstructionPVC
Features5V3A Fast charging, 480 Mbps Data transmission, USB DIY Cable

Questions about this item

What type of USB port on my board or device must I have to plug this cable in?

You need a standard USB Type A female port, because the cable terminates in a USB Type A male plug.

Will the cable still carry data if I connect it to an older USB 1.1 header?

The cable supports up to 480 Mbps and will fall back to the slower speed of the older port.

How can I confirm the cable is delivering both power and data after I solder the four wires?

Measure 5 V between the red and black wires and verify the white and green pair carries a 480 Mbps signal with a USB analyser.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.