We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Short braided USB cable with 9/10-pin motherboard header and standard USB-A plug

Vszerda

Vszerda CY-U2-076 9/10Pin Male to USB 2.0 Male Braided Cable 20cm

SKU CH-66ZM-0N52Q

Connects a motherboard 9/10-pin header to an external USB 2.0 port at 480 Mbps with a 20 cm nylon-braided cable

  • TypeUSB 2.0
  • Connector TypeUsb 2.0
  • Cable Length0.2
  • Length0.2
  • Connector DetailUsb 2.0
  • Speed480 megabits_per_second
  • Connect motherboard 9/10-pin header to external USB 2.0 port
  • Transfer data at up to 480 Mbps with USB 2.0 speed
  • Deliver up to 5 V 2 A power to connected devices
  • Nylon braided jacket resists tangling and adds durability
  • Compact 20 cm length keeps internal routing tidy

Motherboard header adapter

The Vszerda CY-U2-076 converts an internal 9/10-pin USB 2.0 header into a standard external USB 2.0 Type-A port. It is intended for PC builders who need front-panel or bracket-mounted USB access without occupying a rear I/O slot. The 20 cm length suits tight routing behind a motherboard tray or inside a compact chassis.

Signal and power limits

The cable carries USB 2.0 signalling at 480 megabits per second and supplies up to 5 volts at 2 amperes from the header. No active electronics are present, so thermals and noise are not applicable; power draw matches the attached peripheral up to the header rating. The short run keeps voltage drop minimal for compliant devices.

Braided construction and fit

A nylon braided jacket resists tangling and abrasion during assembly and later service. The 9/10-pin plug fits the common keyed header found on most desktop boards, while the Type-A end accepts any USB 2.0 peripheral. Builders who require longer reach or internal device mounting instead of an external port should choose a different cable.

Highlights

  • Connect motherboard 9/10-pin header to external USB 2.0 port
  • Transfer data at up to 480 Mbps with USB 2.0 speed
  • Deliver up to 5 V 2 A power to connected devices
  • Nylon braided jacket resists tangling and adds durability
  • Compact 20 cm length keeps internal routing tidy

Specifications

Brandchenyang
ModelCY-U2-076
TypeUSB 2.0
Connector TypeUsb 2.0
Cable Length0.2
Length0.2
Connector DetailUsb 2.0
Speed480 megabits_per_second
Featuresshock-resistant

Questions about this item

How do I plug the 9/10Pin male end into my motherboard header without bending pins?

Align the missing-pin key on the 9/10Pin connector with the blocked hole on the motherboard USB header, press straight down until the shroud seats fully, then secure the external USB 2.0 Type-A port to a chassis slot.

Will the nylon braid or the 9/10Pin connector need replacement after repeated plug cycles?

The nylon braid is rated for long-term durability and the 9/10Pin header uses standard gold-plated pins; no scheduled replacement is required unless physical damage occurs.

At what point does the 20 cm length or 5 V 2 A power limit become a bottleneck during sustained transfers?

The 20 cm cable meets USB 2.0 signal-integrity specs at 480 Mbps, and the 5 V 2 A ceiling is reached only when a connected device draws more than 2 A continuously.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.