We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black sleeved PWM fan hub splitter cable with five connectors, 15.7 inch length

Vszerda

Vszerda 4/3PIN PWM Fan Hub 1 to 5 Sleeved 15.7 Inch

SKU CH-KTGY-SP56G

Splits one PWM or 3-pin header into five sleeved fan connectors over 15.7 inches

  • Connect up to five fans from one motherboard header
  • PWM control keeps speeds in sync across all ports
  • 7 inch sleeved cables reach across full-size cases
  • Works with both 3-pin and 4-pin fan connectors

1-to-5 PWM fan hub for compact builds

This PWM fan hub splits a single motherboard header into five 4-pin or 3-pin connectors so multiple case fans run from one control point. The sleeved cables keep routing tidy inside small-form-factor or mid-tower cases. It suits builders who want synchronised speed curves without adding a separate controller. No external power adapter is required because the hub draws from the motherboard header.

Passive thermal design with 15.7 inch leads

The board has no active cooling; it relies on case airflow to dissipate the minimal heat from the splitting circuitry. Noise stays at the level of the connected fans because the hub adds no moving parts. Power draw is limited to what the single motherboard header can supply, so total fan current must stay within that header's rating. Longer cable runs are not supported beyond the provided length.

Highlights

  • Connect up to five fans from one motherboard header
  • PWM control keeps speeds in sync across all ports
  • 7 inch sleeved cables reach across full-size cases
  • Works with both 3-pin and 4-pin fan connectors

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the 4/3PIN PWM fan hub and what step is often missed?

Connect the 4-pin PWM lead to the motherboard CPU fan header for speed control, then attach up to five 3-pin or 4-pin fans to the hub outputs; the step often missed is ensuring the hub receives auxiliary power from the PSU.

What maintenance or replacement will the 15.7 Inch sleeved fan hub need later?

The sleeved cables resist abrasion, so the hub itself needs no scheduled maintenance; replace it only if a connector loosens or a fan fails to spin up despite correct PWM wiring.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.