We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Square black DC cooling fan 60 by 60 by 15 mm

Vszerda

Vszerda 2406KL-05W-B59 Cooling Fan DC 24V 0.13A 3.12W 4600 RPM 60×60×15mm

SKU CH-N38S-305A3 MPN 2406KL-05W-B59.

DC 24V 0.13A 4600 RPM 60×60×15mm cooling fan compatible with Fanuc systems

  • DC 24V operation matches Fanuc system power rails
  • 4600 RPM airflow keeps components within thermal limits
  • 60×60×15 mm frame fits standard 6 cm mounting holes
  • 12 W draw minimises load on 24 V supply
  • Brand-new unit includes single fan for direct replacement

Fanuc-compatible replacement fan

This 24 V DC axial fan matches the Fanuc 2406KL-05W-B59 part number and fits equipment requiring a 60×60×15 mm frame. It draws 0.13 A at 3.12 W and spins at 4600 RPM. Maintenance teams and integrators can install it as a direct drop-in for worn or failed original units.

Thermals, noise and power in normal use

Rated at 3.12 W, the motor adds minimal heat to the enclosure while moving air across the heatsink. At 4600 RPM the airflow is steady and the acoustic signature stays low enough for typical industrial cabinets. The 24 V supply rail keeps current at 0.13 A, simplifying wiring and fuse selection.

Behaviour under sustained load

Continuous operation at 4600 RPM maintains consistent airflow without the speed drop-off seen in some lower-rated fans. The 3.12 W power draw remains stable over long shifts, so thermal margins in the host system stay predictable. Builders needing variable speed or PWM control should verify the host controller supports this fixed-speed model.

Highlights

  • DC 24V operation matches Fanuc system power rails
  • 4600 RPM airflow keeps components within thermal limits
  • 60×60×15 mm frame fits standard 6 cm mounting holes
  • 12 W draw minimises load on 24 V supply
  • Brand-new unit includes single fan for direct replacement

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the 60×60×15 mm Fanuc-compatible fan and what step is often missed?

Mount the fan using the four corner holes, connect the two-wire lead to a 24 V DC source observing polarity, and verify airflow direction matches the chassis exhaust path — the step most often missed is confirming the arrow on the frame points toward the intended exhaust side

What maintenance or replacement will this 4600 RPM cooling fan need over time?

The sleeve-bearing motor will eventually wear; plan to replace the unit when noise rises or speed drops below spec, and clean dust from the blades and vent openings every few months with low-pressure air to delay that point

What is the first limit that appears when this 3.12 W fan runs continuously at 4600 RPM?

The 0.13 A current draw at 24 V sets the thermal ceiling; if the enclosure cannot dissipate the 3.12 W heat load, the fan’s own temperature rises until bearing life shortens or the over-temperature protection trips

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.