Vszerda
Vszerda 12V DC Power Connector 5.5mm x 2.1mm 5 Male 5 Female
Ten screw-terminal DC barrel plugs and jacks in the common 5.5 mm by 2.1 mm size for 12 V equipment
- Solder-free screw terminals speed up installation
- Screw-lock design prevents loosening and poor contact
- 5 mm × 2.1 mm barrel size fits standard 12 V gear
- Five male and five female plugs cover both ends of a run
- Sturdy plastic-and-metal housing withstands outdoor and holiday use
Screwable DC Connector Kit
This 12 V DC connector kit contains five male and five female plugs sized 5.5 mm by 2.1 mm. Each barrel jack uses screw terminals so no soldering is required. A standard slotted screwdriver is all you need to secure the wires. The plastic and metal construction gives a firm grip that resists loosening over time.
Replaces Soldered Barrel Plugs
Swap out soldered or crimped barrel connectors when a faster, tool-free repair is needed. The screw terminals let you rewire LED strips, CCTV cameras or holiday lights in minutes instead of heating a joint. The upgrade is worth it whenever you must change cables often or work in tight spots where a soldering iron is impractical.
Fits 5.5 mm x 2.1 mm Power Leads
The connectors accept standard 5.5 mm outer and 2.1 mm inner diameter barrel cables used on many 12 V devices. They free you from permanent solder joints and let you disconnect equipment for storage or testing. Each plug locks with a single screw so the link stays solid on outdoor cameras, solar links or seasonal lighting.
Highlights
- Solder-free screw terminals speed up installation
- Screw-lock design prevents loosening and poor contact
- 5 mm × 2.1 mm barrel size fits standard 12 V gear
- Five male and five female plugs cover both ends of a run
- Sturdy plastic-and-metal housing withstands outdoor and holiday use
Specifications
No published specifications for this item yet.
Questions about this item
What cable diameter fits the 2.1 mm inner and 5.5 mm outer barrel of these Vszerda connectors?
The connectors accept cables that match a 2.1 mm centre pin and 5.5 mm barrel, the standard size quoted for this 12 V DC plug.
Which tool is needed to secure the screw terminals on the male and female plugs?
A standard slotted screwdriver loosens and tightens the terminal screws; no soldering is required.
When should I inspect or replace the screw-terminal connectors in a permanent installation?
Check the screw tightness after the first 24 hours of use and periodically thereafter; the supplier covers defects for 18 months.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



