We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper 45-degree street elbow press fitting with EPDM seal

Viega

Viega ProPress 0926.1XL copper 45° street elbow 2-1/2" press-fit FTG EPDM 200 psi 250°F

SKU CH-2DYC-A5B5Q

Copper 45° street elbow with press-fit and FTG ends rated for 200 psi and 250°F

  • Press-fit connection installs without soldering or threading
  • 45° street elbow redirects flow in tight copper runs
  • EPDM O-ring seals potable water up to 250 °F
  • Copper body rated for 200 psi operating pressure
  • Meets ASTM B75 and ASTM B88 material standards

Copper Press-Fit Street Elbow

The Viega ProPress 0926.1XL is a copper 45-degree street elbow designed for potable water systems. It connects a 2-1/2 inch press-fit end to a 2-1/2 inch FTG end using a flameless press tool. The EPDM O-ring seals at up to 200 psi and 250 degrees F. It meets ASTM B75 and ASTM B88 standards.

EPDM Seal and Press Connection

The factory-installed EPDM O-ring removes the need for flux, solder or open flame during installation. Pressing the fitting creates a permanent, leak-resistant joint on compatible copper tubing. This method reduces installation time compared to traditional sweating and eliminates fire-hazard concerns on site. The 45-degree angle allows directional changes in tight runs.

Verify Tubing and Press Tool Compatibility

Confirm that your existing copper tubing matches the 2-1/2 inch size for both the press-fit and FTG ends. Ensure you have a press tool and jaw set rated for this diameter and approved for Viega ProPress XL fittings. The system pressure and temperature must not exceed 200 psi or 250 degrees F. This fitting is not intended for gas, oil or non-potable applications.

Highlights

  • Press-fit connection installs without soldering or threading
  • 45° street elbow redirects flow in tight copper runs
  • EPDM O-ring seals potable water up to 250 °F
  • Copper body rated for 200 psi operating pressure
  • Meets ASTM B75 and ASTM B88 material standards

Specifications

BrandViega

Questions about this item

Will the EPDM O-ring need periodic replacement on this 2-1/2" ProPress elbow?

The EPDM O-ring is factory-sealed inside the copper body and designed to last the life of the fitting; no scheduled replacement is required.

What pressure limit governs continuous service at 250 °F for this street elbow?

The fitting is rated for a maximum operating pressure of 200 psi at its 250 °F temperature limit.

Does the copper body run hot or create noise when hot water circulates all day?

Copper conducts heat so the elbow will reach water temperature, but the press-fit joint itself adds no vibration or noise.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.