We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Steel press-fit elbow, zinc-nickel finish, ninety-degree bend

Viega

Viega MegaPressG 90° elbow 1-1/2" press-fit steel zinc-nickel 25221

SKU CH-4AGX-4PX61

A 90-degree press-fit steel elbow for air, fuel or natural gas lines rated to 125 psi and 180 degrees F

  • Press-fit design speeds installation without welding
  • 90-degree elbow redirects flow in tight spaces
  • Zinc-nickel coating resists corrosion on steel body
  • HNBR O-ring seals air, fuel and natural gas lines
  • Rated 125 psi and 180 °F for demanding service

MegaPressG 90° elbow for 1-1/2" pipe

This zinc-nickel plated steel fitting connects two 1-1/2 inch pipes at a 90 degree angle using press-fit ends. It is intended for air, fuel and natural gas distribution systems where a secure, flame-free joint is required. The HNBR O-ring provides the seal at each connection point.

Press-fit joint rated to 125 psi and 180°F

The press-fit interface eliminates threading or welding on site, reducing installation time and fire risk. System pressure must not exceed 125 psi and the media temperature must stay at or below 180 degrees Fahrenheit. Exceeding either limit can compromise the O-ring seal and the zinc-nickel coating.

Replaces threaded or welded 90° elbows in gas piping

Use this fitting when local code permits press-fit connections for fuel gas and a right-angle turn is needed on 1-1/2 inch steel pipe. It is not suited for systems operating above the stated pressure or temperature ratings, or for pipe sizes other than 1-1/2 inch.

Highlights

  • Press-fit design speeds installation without welding
  • 90-degree elbow redirects flow in tight spaces
  • Zinc-nickel coating resists corrosion on steel body
  • HNBR O-ring seals air, fuel and natural gas lines
  • Rated 125 psi and 180 °F for demanding service

Specifications

BrandViega

Questions about this item

Should I choose the 1-1/2" press-fit version or a different size for my gas line?

This elbow is a 1-1/2" press-fit fitting on both ends, designed for air, fuel and natural gas with an HNBR O-ring and zinc-nickel coating.

What does the 125 psi rating mean when the fitting is installed in a real system?

It is the maximum operating pressure the joint can hold at up to 180 °F, so the installed line must not exceed 125 psi during service.

How does the press-fit connection limit what pipe or tools I can use?

The press-fit ends require compatible steel pipe and a press tool approved for the MegaPressG system; no threading, welding or bolt holes are involved.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.